125
GB
Additional Information
Cannot play back content.
• Some Internet content requires registration
via a computer before it can be played.
“Control for HDMI” cannot be set to
“On.”
• Set “Zone2 Out” in the “HDMI Settings”
to “Off.”
The Control for HDMI function does not
work.
• Check the HDMI connection (page 26, 28,
30, 31).
• Make sure “Control for HDMI” is set to
“On” in the HDMI Settings menu.
• When “Zone2 Out” is set to “On,” the
Control for HDMI function does not work.
• Make sure the connected equipment is
compatible with the Control for HDMI
function.
• Check the Control for HDMI settings on
the connected equipment. Refer to the
operating instructions of the connected
equipment.
• If you change the HDMI connection,
connect/disconnect the AC power cord
(mains lead), or there is a power failure,
repeat the procedures of “Preparing for the
“BRAVIA” Sync” (page 68).
• When you select “HDMI OUT B” or
“OFF,” the Control for HDMI function
does not work properly.
• If you select “HDMI OUT A” after you
have selected “HDMI OUT B” or “OFF,”
the Control for HDMI function may not
work properly for a while. This is because
the equipment connected to the HDMI
OUT A jack must re-recognize the
receiver that is equipped with the Control
for HDMI function. If the Control for
HDMI function does not work properly for
a long time, perform the steps given in
“Preparing for the “BRAVIA” Sync”
(page 68).
• The types and the number of devices
which can be controlled by the “BRAVIA”
Sync feature are restricted in the HDMI
CEC standard as follows.
– Recording equipment (Blu-ray Disc
recorder, DVD recorder, etc.): up to 3
devices
– Playback equipment (Blu-ray Disc
Player, DVD player, etc.): up to 3
devices
– Tuner-related equipment: up to 4
devices (The receiver uses one of them
for its GUI operations.)
– Audio System (AV Receiver): up to 1
devices
When you try to use the One-Touch
Play function, input is not switched as
intended.
• Check to see if “Zone2 Out” is set to “Off.”
• Check the assignment of the HDMI input
(page 73). When you assign multiple
inputs to the same HDMI input jack, if you
use the One-Touch Play function on the
equipment connected to the HDMI input,
the input you have assigned last is
preferentially selected.
The Audio Return Channel (ARC) does
not work.
• Make sure “Control for HDMI” is set to
“On” in the HDMI Settings menu.
• Make sure that the INPUT MODE for
“TV” is set to “AUTO” (page 72).
The remote control does not function.
• Point the remote control at the remote
sensor on the receiver (page 10).
• Remove any obstacles in the path between
the remote control and the receiver.
• Replace all the batteries in the remote
control with new ones, if they are weak.
“BRAVIA” Sync (Control for
HDMI)
Remote control
continued
Comments to this Manuals