Sony STR-DA2800ES User Manual download pdf (Page 117)

117

GB

Additional Information

Troubleshooting

If you experience any of the following

difficulties while using the receiver, use this

troubleshooting guide to help you remedy the

problem. Should any problem persist, consult

your nearest Sony dealer.

The receiver is turned off

automatically.

• “Auto Standby” is set to “On” (page 101).

• The sleep timer function is working

(page 78).

• “PROTECTOR” is working (page 126).

The receiver is turned on automatically.

• “Control for HDMI” is set to “On” or

“Pass Through” is set to “Off.” In this case,

the receiver may be turned on by operating

other equipment connected to it.

No picture and no sound are output, or

the picture and sound are corrupted.

• The receiver is placed near equipment

such as a television, VCR, or tape deck.

If the receiver is being used in

combination with a television, VCR, or

tape deck, and is placed too close to that

equipment, noise may result, and picture

quality may suffer. This is especially likely

when using an indoor antenna (aerial).

Therefore, we recommend using an

outdoor antenna (aerial).

The top of the receiver is hot.

• Phenomenon is specific to this amplifier.

This is not a malfunction. If “Control for

HDMI” or “Network Standby” is set to

“On,” or “Pass Through” is set to “On,” or

“Auto,” the power for zone 2 is turned on,

the top of the receiver may become hot

even while the receiver is in standby mode.

This condition occurs because current is

flowing in the internal circuits of the

receiver, and this is normal.

There is no picture or an unclear

picture appears on the TV screen or

monitor, regardless of type of picture.

• Select the appropriate input on the receiver

(page 46).

• Set your TV to the appropriate input mode.

• Move your TV away from the audio

equipment.

• Assign the component video input

correctly (page 73).

• The input signal should be same as input

when you are up-converting an input

signal with this receiver (page 19).

• Make sure that cables are correctly and

securely connected to equipment.

• Depending on the playback equipment,

equipment may need to be set up. Refer to

the operating instructions supplied with

the equipment.

Images appear later than the

associated sound is played.

• Depending on the equipment connected to

the HDMI jack, or the source played back,

images may appear later than the

associated sound. In this case, change the

setting of “A/V Sync” in the Audio

Settings menu (page 91).

Recording cannot be carried out.

• Check that the equipment is connected

correctly (page 28).

• Select the source equipment (page 46).

• Check the connection of the recording

deck according to the video signals you

want to record. Analog input signals

(composite video) can be output only from

the analog output jacks.

• Video input signals via the HDMI IN jacks

cannot be recorded.

General

Video

continued

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 133 134

Comments to this Manuals

No comments