Sony MHC-V800 User Manual download pdf (Page 22)

Chapter 4: the Tape Player

EN

22

To stop recording

Press p on the cassette deck.

To reduce noise during MW (AM)

recording

If a whistling noise is heard while

recording, reorient the AM loop antenna for

optimum reception.

To activate DOLBY NR

When you want to reduce the hiss noise in

low-level high-frequency signals, press

DOLBY NR so that “DOLBY NR B” appears

in the display after step 4.

Recording From

Another Tape

(dubbing)

Dubbing Another Tape

Automatically

You can record the whole tape onto another

automatically by using high speed dubbing.

Use the buttons on the unit to do this

operation and TYPE I (normal) or TYPE II

(CrO2) tape for dubbing.

1 Press § EJECT and insert a recorded

tape in deck A with the side you want to

play facing forward.

Also, insert a blank tape in deck B with

the side you want to record on facing

forward.

Recording and playback will start from

the front side of the tape, unless you

change the playing direction before

recording.

Recording From the

Radio

You can record from the tuner onto a tape.

Use TYPE I (normal) or TYPE II (CrO2)

tape.

1 Press § EJECT and insert a blank tape

into deck B with the side you want to

record on facing forward.

Recording will start from the front side

of the tape, unless you change the

playing direction before recording.

Make sure the tabs on the cassette have

not been removed.

2 Press TUNER/BAND several times until

the desired radio band appears.

3 Tune in the radio station you want to

record. (See “Listening to the Radio”, or

“Playing Preset Radio Stations” for

details.)

4 Select dual or single-sided recording.

* Recording always stops at the end of the

reverse side. Be sure to start from the

front side.

5 Press r REC.

Deck B stands by for recording.

6 Press P PAUSE to release recording

pause.

Recording starts.

Recording a CD: Selecting

Tape Length Automatically

(tape select edit)

After inserting CDs, press EDIT in step 3 so

that “TAPE SELECT” appears in the

display.

The player divides the selections for both

side A and B automatically and makes two

programs of almost the same length. The

track order remains the same as the

original. After programming, the most

suitable tape length is indicated in the

display.

Note

You cannot use the tape select edit if you

have selected the desired tracks

beforehand.

Recording a CD: Specifying

Track Order (program edit)

You can adjust the total recording time to

the tape length while making a program.

1 Do steps 1 through 7 of “Playing Tracks

in the Desired Order (program play)”,

then press P on the remote to pause

recording at the end of side A.

“P” appears and the total playing time is

reset to 0.00.

2 Repeat steps 4 through 7 to make a

program for side B.

3 After programming, do step 7 through

10 of “Recording a CD: Specifying Tape

Length (time edit)”.

Note

If the last portion of the track is recorded on

the leader at the end of the tape, recording

may be incomplete.

12563 250 500 1k 2k 4k 8k 16k(Hz)

DOLBY NR

CD

DISC PROGRAM

12345

678

REC

VOLUME

To record

One side of the

tape

Both sides*

Press DIRECTION to

select

A

ß or RELAY

POWER m ON

p

1

6

5

2

4

DOLBY NR

Recording side facing forward

POWER m ON

1 1

4

2

3

p

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 148 149

Comments to this Manuals

No comments