Sony MEX-N5200BT User Manual download pdf (Page 29)

29GB

BLUETOOTH function

The connecting device cannot detect this

unit.

 Before the pairing is made, set this unit to

pairing standby mode.

 While connected to two BLUETOOTH

devices, this unit cannot be detected from

another device.

– Disconnect either connection and search

for this unit from another device.

 When the device pairing is made, set the

BLUETOOTH signal output to on (page 9).

Connection is not possible.

 The connection is controlled from one side

(this unit or BLUETOOTH device), but not

both.

– Connect to this unit from a BLUETOOTH

device or vice versa.

The name of the detected device does not

appear.

 Depending on the status of the other

device, it may not be possible to obtain

the name.

No ringtone.

 Adjust the volume by rotating the control

dial while receiving a call.

 Depending on the connecting device, the

ringtone may not be sent properly.

– Set [RINGTONE] to [1] (page 21).

 The front speakers are not connected to

the unit.

– Connect the front speakers to the unit.

The ringtone is output only from the

front speakers.

The talker’s voice cannot be heard.

 The front speakers are not connected to

the unit.

– Connect the front speakers to the unit.

The talker’s voice is output only from the

front speakers.

A call partner says that the volume is too

low or high.

 Adjust the volume accordingly using Mic

gain adjustment (page 15).

Echo or noise occurs in phone call

conversations.

 Lower the volume.

 Set EC/NC Mode to [EC/NC-1] or [EC/NC-2]

(page 15).

 If the ambient noise other than the phone

call sound is loud, try reducing this noise.

E.g.: If a window is open and road noise,

etc., is loud, shut the window. If an air

conditioner is loud, lower the air

conditioner.

The phone is not connected.

 When BLUETOOTH audio is played, the

phone is not connected even if you press

CALL.

– Connect from the phone.

The phone sound quality is poor.

 Phone sound quality depends on

reception conditions of cellular phone.

– Move your car to a place where you can

enhance the cellular phone’s signal if

the reception is poor.

The volume of the connected audio device

is low (high).

 Volume level will differ depending on the

audio device.

– Adjust the volume of the connected

audio device or this unit (page 20).

The sound skips during playback of a

BLUETOOTH audio device.

 Reduce the distance between the unit and

the BLUETOOTH audio device.

 If the BLUETOOTH audio device is stored in

a case which interrupts the signal, remove

the audio device from the case during use.

 Several BLUETOOTH devices or other

devices which emit radio waves are in use

nearby.

– Turn off the other devices.

– Increase the distance from the other

devices.

 The playback sound stops momentarily

when the connection between this unit

and the cellular phone is being made. This

is not a malfunction.

The connected BLUETOOTH audio device

cannot be controlled.

 Check that the connected BLUETOOTH

audio device supports AVRCP.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 83 84

Comments to this Manuals

No comments