Sony VPL-CX85 User Manual Page 46

  • Download
  • Add to my manuals
  • Print
  • Page
    / 192
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 45
GB
46 Maintenance
Sound
Remote Commander/Presentation tool
The picture is too dark. Contrast or brightness has not been adjusted properly.
c Adjust the contrast or brightness in the “Adjust Picture...” menu
properly (see page 33).
The lamp has burnt or dims.
c Replace the lamp with a new one (see page 41).
The picture is not clear. Picture is out of focus.
c Adjust the focus (see page 25).
Condensation has occurred on the lens.
c Leave the projector for about two hours with the power on.
The image extends beyond
the screen.
The APA key is pressed although there are black edges around the
image.
c Display the full image on the screen and press the APA key.
c Adjust “Shift” in the INPUT SETTING menu properly (see
page 35).
The picture flickers. “Dot Phase” in the INPUT SETTING menu has not been adjusted
properly.
c Adjust “Dot Phase” in the INPUT SETTING menu properly
(see page 35).
Symptom Cause and Remedy
No sound. Cable is disconnected or the connections are wrong.
c Check that the proper connections have been made (see page
20).
The audio connecting cable is incorrect.
c Use a no-resistance stereo audio cable (see page 20).
The sound is muted.
c Press the AUDIO MUTING key to release the audio muting (see
page 16).
The sound is not adjusted properly.
c Adjust the sound with the VOLUME +/– key on the Remote
Commander or adjust “Volume” in the PICTURE SETTING
menu (see page 33).
Speaker” is set to “Off.
c Set “Speaker” in the SET SETTING menu to “On” (see page
37).
Symptom Cause and Remedy
The Remote Commander
does not work.
The Remote Commander batteries are dead.
c Replace with a new battery (see page 17).
The COMMAND ON/OFF switch is set to OFF.
c Set to ON.
The PJ/NETWORK selector switch is set to NETWORK.
c Set to PJ.
The computer cannot be
controlled with the Remote
Commander.
The USB cable is not connected.
c Connect the projector to the computer using the USB cable.
You are operating the Air Shot.
c When using the Air Shot, the computer cannot be controlled
with the Remote Commander.
Symptom Cause and Remedy
Page view 45
1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 191 192

Comments to this Manuals

No comments