Sony RM-VL1400T User Manual download pdf (Page 14)

14

GB

If the Remote Commander

does not seem to be

working properly

If the learned button does not operate

properly, clear the learned signal first

(page 14), then perform the learning

procedure from step 1 again. (For

example, if the volume becomes very loud

after pressing the 2 (volume) + button

just once, noise may have interfered

during the learning procedure.)

For accurate learning

• Do not move the remote units during the

learning procedure.

• Be sure to press and hold the button of

the other remote control until you hear

the confirmation beep.

• Use fresh batteries in both remote

control units.

• Avoid learning in places under direct

sunlight or strong fluorescent light, or

near a plasma display. (It may cause

noise interference.)

• The remote control signal direction may

differ depending on the remote control.

If Learning does not work, try changing

the position of the remote control.

• When you programme the Remote

Commander from a remote control unit

with an interactive signal exchange

system (supplied with some Sony

receivers and amplifiers), the response

signal of the component may interfere

with the Learning of the Remote

Commander. In such a case, move to

another room, etc., where signals will

not interfere.

IMPORTANT

Be sure to place the Remote

Commander out of the reach of

small children or pets.

Also, set the Hold function to lock all the

buttons on the Remote Commander (page

11) when it is not used. Devices such as air

conditioners, heaters, electric appliances,

and electric shutters or curtains receiving an

infrared signal can be dangerous if misused.

Changing or clearing the

function of a “learned”

signal

To change the “learned” function, clear it

first and perform the learning procedure

again.

1 While pressing the (light)

button, press the OTHER

button.

“SET MODE” appears as the screen

title.

2 Press the V/v buttons to

select “2 LEARN”, then press

the OK button or the centre

Label select button.

“LEARN” appears as the screen title.

Tip

If a number is displayed before the menu,

you can select the menu by pressing the

number button.

3 Press the COMPONENT

select button or Label select

button you want to clear the

learned signal from.

The selected A/V component’s label

appears in the second line on the

screen.

4 While pressing the button on

the Remote Commander you

want to clear the learned

signal from, press the

(light) button.

A beep sounds and the cleared button

name and “OK” appear on the screen.

Tip

If you press again the button which you

cleared the learned signal from while

pressing the

(light) button, the label of

the button function and name will be

initialized.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 95 96

Comments to this Manuals

No comments