Sony RM-VL1400T User Manual download pdf (Page 33)

Problem

A Component Macro does not

function correctly.

The display turns off

automatically.

The set mode closes unexpectedly

while setting.

The confirmation beep does not

sound.

The confirmation beep sounds

even though beep sound is set to

off.

“E” appears in the screen.

The Remote Commander does not

enter set mode.

Solution

• When programming a Component Macro, programme the

actions in the correct order (page 18).

• Change the direction of the Remote Commander. If it

does not improve, position the Remote Commander

closer to each A/V component.

• Check that the programmed A/V components are ready to

receive the signals correctly (page 18).

• If you changed the preset code or programmed remote

signals after programming the Component Macro, the

new signal will be transmitted when executing the

Component Macro.

• The interval between programmed steps is too short. See

“To check the programmed steps of a Component Macro

and add a delay action” (page 19) to extend the interval,

or change the order of the steps.

The Remote Commander is preset at the factory to turn off

the display automatically if you do not operate it for over

30 seconds (automatic-off time). You can change the

automatic-off time between 1-60 seconds (page 26).

The set mode closes if you do not operate the Remote

Commander for over 60 seconds. Perform the next step

within 60 seconds.

Beep sound is set to off. Set it on (page 27).

A confirmation beep sounds during set mode, even if the

beep sound is set to off.

The batteries are weak. Replace them with new ones.

If “E” appears on the screen, the Remote Commander

cannot enter into the set mode. Replace the batteries with

new ones.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 95 96

Comments to this Manuals

No comments

Sony RM-VL1400T User Manual Page 33

Comments to this Manuals

Related products and manuals for Remote controls Sony RM-VL1400T