Sony RM-VL1400T User Manual download pdf (Page 13)

13

GB

Programming a signal on

the COMPONENT select

button

1 Perform steps 1-3 of the

learning procedure (page 12).

2 Press and hold the

COMPONENT select button

or Label select button on

which you want to programme

the signal.

The display turns off and the Remote

Commander enters into the Learning

mode.

3 Press and hold the button on

the other remote control until

you hear a beep.

A beep sounds and the learned button

name and “OK” appear in the third

line on the screen.

4 To programme signals on

other COMPONENT select

buttons or Label select button,

repeat steps 2 and 3.

5 Press the (light) button.

“LEARN” appears as the screen title.

6 Press the (light) button or

the RETURN button twice.

The set mode closes, and the Remote

Commander returns to standby for

operating the A/V components.

Notes

• If you do not input anything into the Remote

Commander within 60 seconds between each

step, the setup procedure will be cancelled

and the set mode closes. Start over from the

beginning.

• If you do not perform step 6 within 10

seconds after performing step 5, a beep

sounds twice and the selected button name

and “NG” appear in the third line on the

screen, then the display returns to the screen

shown in step 4. Start over from step 5.

• If the Remote Commander learns signals

incorrectly in step 6, clear the learned signal

by pressing the

(light) button while

pressing the button on which the incorrect

signal was learned (page 14). Start over from

step 5.

• If you programme remote signals on the TV

or amplifier’s volume control buttons using

the Learning function (page 12), those buttons

will also send the learned signal to control

components other than a TV or amplifier.

If you programme remote signals on the

volume control buttons of components other

than a TV or amplifier, those buttons will also

send the learned signal to control other A/V

components instead of controlling the TV or

amplifier’s volume.

•To avoid misoperation, the Remote

Commander will only transmit z/REC

(record) button signals if the button is pressed

and held for over 2 seconds. Therefore, if this

button is used for a learned operation, you

must press and hold it for over 2 seconds.

Continued

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 95 96

Comments to this Manuals

No comments