Sony XR-C9100 User Manual download pdf (Page 27)

27

EN

Adjusting the frequency of the

subwoofer(s)

To match the characteristics of the connected

subwoofer(s), you can cut out the unwanted

high and middle frequency signals entering

the subwoofer(s). By setting the cut-off

frequency (see the diagram below), the

subwoofer(s) will output only low frequency

signals so you can get a clearer sound image.

1 Press (SOURCE) to select a source (tuner,

tape, CD, or MD).

2 Press (SOUND) for two seconds.

3 Press (SOUND) repeatedly until “SUB”

appears.

4 Rotate the dial to select the desired cut-

off frequency.

The cut-off frequency in the display

changes as follows.

62 n 78 n 99 n 125* n 157 n 198 Hz

* Factory-set frequency

5 Press (SOUND) for two seconds.

After the frequency setting is complete, the

display returns to the normal playback

mode.

Level

62 125 198

Cut-off frequency

Frequency (Hz)

Adjusting the fader (FAD)

Normally, with the DSP mode on, the volume

of the output sound from the rear speakers is

lowered automatically to improve the

efficiency of the listening position setting. If

you want to raise the rear speaker volume,

adjust the fader.

1 Follow steps 1 to 3 of “Selecting a

surround menu” (page 24).

2 Press (SOUND) repeatedly until “FAD”

appears.

3 Rotate the dial to adjust the fader.

After three seconds, the display returns to

the normal playback mode.

Adjusting the volume of

the subwoofer(s)

1 Press (SOURCE) to select a source (tuner,

tape, CD, or MD).

2 Press (SOUND) repeatedly until “SUB”

appears.

3 Rotate the dial to adjust the volume.

After three seconds, the display returns to

the normal playback mode.

Tip

When you rotate the dial to turn the volume all

the way down, “Sub ATT” appears and the cut-off

frequency of the subwoofer is disabled.

Increases front speaker volume

Decreases front speaker volume

DSP

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Comments to this Manuals

No comments