Sony HT-M7 User Manual download pdf (Page 55)

55

GB

Additional Information

When the receiver is in standby mode,

there is no image output from the TV.

• When the receiver enters into standby

mode, image are from the last HDMI

equipment selection before you turned off

the receiver. If you are enjoying other

equipment, play the equipment and

perform the One-Touch Play operation, or

turn on the receiver to select the HDMI

equipment you want to enjoy.

• Make sure “PASS.THRU” is set to “ON”

in the HDMI menu if you connect

equipment not compatible with the

“BRAVIA” Sync to the receiver (page 51).

Recording cannot be carried out.

• Check that the equipment are connected

correctly.

• Select the source equipment using the

input buttons (page 31).

• Video input signals via HDMI IN and

COMPONENT VIDEO IN (HT-M7/

HT-M5 only) jacks cannot be recorded.

• Copyright protection to prevent recording

is contained in the sources. In this case,

you may not be able to record from the

sources.

There is no sound, no matter which

equipment is selected, or only a very

low-level sound is heard.

• Check that all connecting cords are

inserted to their input/output jacks for the

respective jacks of the receiver, speakers

and the equipment.

• Check that both the receiver and all

equipment are turned on.

• Check that MASTER VOLUME is not set

to “VOL MIN”.

• Press MUTING on the remote control to

cancel the muting function.

• Try pressing the input button on the remote

control or turning INPUT SELECTOR on

the receiver to select the equipment of

your choice (page 31).

• When you want to listen to the sound from

the TV speaker, set the “AUDIO.OUT” to

“TV+AMP” in the HDMI menu (page 52).

If you cannot play back multi channel

audio source, set to “AMP”. However, the

sound will not output through the TV

speaker.

• Sound may be interrupted when the

sampling frequency, the number of

channels or audio format of audio output

signals from the playback equipment is

switched.

There is severe hum or noise.

• Check that the speakers and equipment are

connected securely.

• Check that the connecting cords are away

from a transformer or motor, and at least

3 meters (10 feet) away from a TV set or

fluorescent light.

• Move your audio equipment away from

the TV.

• The plugs and jacks are dirty. Wipe them

with a cloth slightly moistened with

alcohol.

There is no sound, or only a very low-

level sound is heard from specific

speakers.

• Check that all the cords are fully inserted

into the jacks on both the receiver and the

equipment.

• Make sure you have connected to both the

L and R jacks of an analog equipment,

analog equipment requires both L and R

jack connections. Use an audio cord (not

supplied).

• Adjust the speaker level (page 30).

• Check that the speaker cords (supplied)

are connected correctly and securely (page

17).

Sound

continued

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 63 64

Comments to this Manuals

No comments