Sony HT-M7 User Manual download pdf (Page 29)

Preparing the Receiver

Setting the voltage

selector

If your receiver has a voltage selector on the

rear panel, check that the voltage selector is set

to the local power supply voltage. If not, use a

screwdriver to set the selector to the correct

position before connecting the AC power cord

to a wall outlet.

Depending on the area, the VOLTAGE

SELECTOR may differ.

Connecting the AC power

cord (mains lead)

Connect the AC power cord (mains lead) to a

wall outlet.

Initializing the receiver

Before using the receiver for the first time,

initialize the receiver by performing the

following procedure. This procedure can also

be used to revert back to the factory default

settings.

Be sure to use the button on the receiver to

perform this operation.

1 Press ?/1 to turn off the

receiver.

2 Hold down ?/1 for 5 seconds.

The “CLEARING” appears on the

display panel for a while, then changes to

“CLEARED”.

Changes or adjustments made to the

settings are now reset to the defaults.

Preparing the Receiver

AC power cord (mains lead)

To the wall outlet

?/1

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 63 64

No comments

Sony HT-M7 User Manual Page 29