Sony PCG-GRX690K User's Guide download pdf (Page 234)

Removing and installing memory modules

Make sure you read Precautions and procedures before you remove or install a memory module. When installing a memory

module, do not open the module package until you are ready to install it. The package protects the module from

Electrostatic discharge (ESD).

To remove a memory module

Turn off the computer and all peripheral devices.

Disconnect the power cord, all cables, and remove the battery if it is installed. See "To remove the battery."

Wait for the computer to cool down.

The interior of the computer becomes extremely hot during operation. Wait at least one hour for the computer to

cool down before you remove the screws.

Use an appropriate screwdriver to loosen and remove the screws on the bottom of the computer.

To avoid damaging the computer, do not remove or loosen any other screws.

Remov ing the Bottom Screws

Touch a metal object (such as the connector panel on the back of your computer) to discharge static electricity.

Remove the memory module by pulling out the tabs (see arrows No. 1), and pulling out the module in the

direction of arrow No. 2. See To install a memory module for more information.

Remov ing a Mem ory Module

To install a memory module

Remove the existing memory module from the computer. See To remove a memory module for more information.

Remove the new memory module from its packaging, and install the memory module by sliding it into the open

slot at a 45-degree angle.

Do not touch any part of the motherboard or the other components inside the computer.

Installing a New Memory Module

Page 234

1 2 ... 229 230 231 232 233 234 235 236 237 238 239 ... 263 264

No comments

Sony PCG-GRX690K User's Guide Page 234