Sony MHC-W55 User Manual download pdf (Page 6)

EN

6

Chapter 1: Setting Up

Inserting the

Batteries

Install two R6 (size AA) batteries in the

supplied remote for remote control.

1Slide the lid to remove it.

2Insert two R6 (size AA) batteries.

Match the + and – to the diagram in the

battery compartment.

3Close the lid.

Battery life

You can expect the remote to operate for

about six months (using Sony SUM-3 (NS)

batteries) before the batteries run down.

When the batteries no longer operate the

remote, replace all the batteries with new

ones.

To avoid battery leakage

If you are not going to use the remote for a

long time, remove the batteries to avoid

damage caused by corrosion from battery

leakage.

Setting the Clock

The built-in clock shows the time in the

display even if the power is off.

Use the buttons on the unit to do this

operation.

Note

Once you set the clock, the demo mode,

that activates when the power is turned off,

is cancelled automatically.

1 Press TIMER.

The stereo enters the clock/timer mode.

2 Press CLOCK SET.

The “AM” and hour indication begin

flashing.

3 Set the current hour by turning the JOG

dial until the correct hour appears.

4 Press ENTER/NEXT.

The minutes indication begins flashing.

5 Set the current minute by turning the

JOG dial until the correct minute

appears.

6 Press ENTER/NEXT.

The clock starts running and the upper

dot flashes. Use the time signal to set the

clock accurately.

The upper dot flashes for the first half of

a minute (0 to 29 seconds), and the

lower dot flashes for the last half of a

minute (30 to 59 seconds).

To check the time while power is on

Press DISPLAY a few times.

The current time is displayed for 8 seconds.

To correct the clock setting

Repeat steps 1 through 6.

flashing

flashing

flashing

SYSTEM

POWER m ON

DISPLAY

2

4,6

1

3,5

flashing

flashing

1 2 3 4 5 6 7 8 9 10 11 ... 58 59

Comments to this Manuals

No comments