Sony DSLR-A200W User Manual download pdf (Page 32)

If dust or debris enters the camera and lands on the image sensor (the part

that acts as the film), it may appear on the photo image, depending on the

shooting environment. If there is dust on the image sensor, use a

commercially available blower brush and clean the image sensor following

the steps below. You can easily brush the dust away using only the blower

brush and the anti-dust function.

Notes

• Cleaning can be performed only when the battery level is (three remaining

battery icons) or more. Low battery power during cleaning can cause damage to the

shutter. The cleaning should be completed quickly. The use of an AC Adaptor/

Charger (not supplied) is recommended.

• Do not use a spray blower because it may scatter vapor inside the camera body.

Cleaning the image sensor

1 Confirm that the battery is fully charged (page 17).

2 Press the MENU button, then

select 3 with b/B on the

controller.

MENU button

3 Select [Cleaning mode] with v/V

on the controller, then press the

center of the controller.

The message “After cleaning, turn

camera off. Continue?” appears.

4 Select [OK] with v on the controller, and press the center of the

controller.

After the image sensor vibrates for a short time, the mirror in front is lifted.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 157 158

No comments

Sony DSLR-A200W User Manual Page 32