Sony STR-KS2300 User Manual download pdf (Page 25)

Getting Started

Before using the receiver for the first time,

initialize the receiver by performing the

following procedure. This procedure can also

be used to return settings you have made to

their factory defaults.

Be sure to use the buttons on the receiver for

this operation.

1 Press ?/1 to turn off the

receiver.

2 Hold down ?/1 for 5 seconds.

“CLEARING” appears on the display for

a while, then “CLEARED” appears.

All the settings you have changed or

adjusted are reset to the initial settings.

Insert two R6 (size-AA) batteries in the

RM-AAU022 (Models of area code U, UC,

CA only) or RM-AAU023 (Models of area

code CEL, CEK, AU, TW, TH only) Remote

Commander.

Observe the correct polarity when installing

batteries.

Notes

• Do not leave the remote in an extremely hot or

humid place.

• Do not use a new battery with old ones.

• Do not mix manganese batteries and other kinds of

batteries.

• Do not expose the remote sensor to direct sunlight

or lighting apparatuses. Doing so may cause a

malfunction.

• If you do not intend to use the remote for an

extended period of time, remove the batteries to

avoid possible damage from battery leakage and

corrosion.

• When you replace the batteries, the remote buttons

may be reset to their factory settings. If this

happens, reassign the buttons again (page 63).

Tip

Under normal conditions, the batteries should last

for about 3 months. When the remote no longer

operates the receiver, replace all the batteries with

new ones.

Performing initial setup

operations

MASTER VOLUME

AUTO CAL MICMUTING

INPUT SELECTOR

PRESET

ACTIVE

STANDBY

TUNING

SOUND FIELD

?/1

1,2

Inserting batteries into the

remote

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 75 76

Comments to this Manuals

No comments

Sony STR-KS2300 User Manual Page 25

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Sony STR-KS2300