Sony STR-DE1015G User Manual download pdf (Page 62)

62

Additional Information

Severe hum or noise is heard.

/ Check that the speakers and components are

connected securely.

/ Check that the connecting cords are away

from a transformer or motor, and at least 10

feet (3 meters) away from a TV set or

fluorescent light.

/ Place your TV away from the audio

components.

/ Make sure you connect a ground wire to the

antenna ground terminal.

/ The plugs and jacks are dirty. Wipe them

with a cloth slightly moistened with alcohol.

No sound is heard from the center speaker.

/ STR-DE1015G : Select a sound mode other

than ACOUSTIC or KARAOKE (see page 37).

/ STR-DE815G / D760Z : Select a sound field

using the center speaker: PRO LOGIC,

MOVIE (except NIGHT THEATER and

MONO MOVIE) (see page 38).

/ STR-DE815G / D760Z : Select the appropriate

center mode (see pages 24 and 25).

/ Adjust the speaker volume appropriately

(see page 23 for STR-DE1015G or pages 24

and 25 for STR-DE815G / D760Z).

No sound or only a very low-level sound is heard from

the rear speakers.

/ Select a sound field other than ACOUSTIC.

/ STR-DE815G / D760Z : Select the appropriate

center mode (see pages 24 and 25).

/ Adjust the speaker volume appropriately

(see page 22 for STR-DE1015G or pages 24

and 25 for STR-DE815G / D760Z).

Surround effect cannot be obtained.

/ Turn on the sound field function.

/ Set DIRECT PASS to OFF.

/ Make sure you set the SPEAKERS selector

correctly (see page 10).

Tuner

Radio stations cannot be tuned in.

/ Check that the antenna is connected securely.

Adjust the antenna and connect an external

antenna if necessary.

/ The signal strength of the stations is too weak

(when you tune in with Automatic Tuning).

Use Direct Tuning (see page 29).

/ Make sure you set the tuning interval

correctly (when you tune in AM stations with

Automatic Tuning) (see page 29 or 54 and 64).

/ No stations have been preset or the preset

stations have been cleared (when you tune in

with Preset Tuning). Preset the stations (see

page 30).

/ Display the frequency by pressing DISPLAY

(when you tune with Automatic Tuning).

Others

IR codes of components cannot be registered.

/ When registering the IR code, be sure to

check the following:

• Point the remote at the IR sensor on the

receiver from a distance of less than 2 inches

(5 cm).

• Hold down the button on the remote for

about 2 or 3 seconds until the “RECEIVING”

display switches to “RELEASE YOUR

REMOTE”.

• Keep the remote pointed horizontally at the

IR sensor until the code is registered.

Recording cannot be made.

/ Check that the components are connected

correctly.

/ Select the playback component with the

remote or with the AUDIO FUNCTION or

VIDEO FUNCTION controls on the front

panel.

A component cannot be selected

/ Check the FUNCTION hookup setting of the

component (see page 58 or 59).

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 68

Comments to this Manuals

No comments