Sony LF-PK1 User Manual download pdf (Page 12)

Setup and Connections

The base station has a normal mode and a setup mode.

Base Station Modes

Normal mode (SETUP MODE LED off)

• You can use NetAV at home and away from home.

• You can make base station settings via a wireless connection.

• You cannot make base station settings.*

* You can make settings via a router if you set [Security] in the [Advanced Setup] page

(1 page 36) to [Enable at all times (Security Level: Low)]. You can also make base station

settings via a wireless connection.

Press the base station power switch

SETUP MODE button

Press the SETUP MODE

button on the rear panel

of the base station.

Keep pressing until the

SETUP MODE LED starts

blinking.

• When the base station reboots.

• When the base station settings

page has not been accessed for

15 minutes.

Setup mode (SETUP MODE LED on)

• You cannot use NetAV at home and away from home.

• You can make base station settings.*

* Use the SSID and WEP key on the sticker of the base station for a wireless connection in setup

mode.

Also, a wireless LAN uses a channel in the 2.4 GHz band when the base station is in setup

mode.

SETUP MODE LED

Status for registration (SETUP MODE LED blinking)

• You can register LocationFree devices only during the first 5 minutes after

the base station is in setup mode. (The base station is still in setup mode

after this 5-minute state.)

• If the 5-minute registration state ends before you finish, switch to the

registration status by pressing and holding the SETUP MODE button

again until the SETUP MODE LED starts blinking.

Blinking

Off

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 58 59

No comments

Sony LF-PK1 User Manual Page 12