Sony XR-CA660X Operations Instructions download pdf (Page 24)

24

Troubleshooting

The following checklist will help you remedy

problems you may encounter with your unit.

Before going through the checklist below, check

the connection and operating procedures.

General

No sound.

• Press the volume + button to adjust the

volume.

• Cancel the ATT function.

• Set the fader control to the centre position for

a 2-speaker system.

The contents of the memory have been

erased.

• The RESET button has been pressed.

t Store again into the memory.

• The power cord or battery has been

disconnected.

• The power connecting cord is not connected

properly.

No beep sound.

• The beep sound is cancelled (page 15).

• An optional power amplifier is connected

and you are not using the built-in amplifier.

The display disappears from/does not

appear in the display window.

• The display disappears if you press and hold

(OFF).

t Press and hold (OFF) again until the

display appears.

• Remove the front panel and clean the

connectors. See “Cleaning the connectors”

(page 21) for details.

Stored stations and correct time are erased.

The fuse has blown.

Makes noise when the ignition key is in the

ON, ACC, or OFF position.

The leads are not matched correctly with the

car’s accessory power connector.

No power is being supplied to the unit.

• Check the connection. If everything is in

order, check the fuse.

• The car does not have an ACC position.

t Press (SOURCE) (or insert a cassette) to

turn on the unit.

The power is continuously supplied to the

unit.

The car does not have an ACC position.

The power aerial does not extend.

The power aerial does not have a relay box.

Tape playback

The sound is distorted.

The tape head is contaminated.

t Clean the head with a commercially

available dry-tape cleaning cassette.

The AMS does not operate correctly.

• There is noise in the space between tracks.

• A blank space is too short (less than 4

seconds).

• A long pause, or a passage of low

frequencies or very low sound level is treated

as a blank space.

Radio reception

Preset tuning is not possible.

• Store the correct frequency in the memory.

• The broadcast signal is too weak.

The stations cannot be received.

The sound is hampered by noises.

• Connect a power aerial control lead (blue) or

accessory power supply lead (red) to the

power supply lead of a car’s aerial booster.

(Only when your car has built-in FM/AM

aerial in the rear/side glass.)

• Check the connection of the car aerial.

• The auto aerial will not go up.

t Check the connection of the power aerial

control lead.

• Check the frequency.

• When the DSO mode is on, the sound is

sometimes hampered by noises.

t Set the DSO mode to “OFF” (page 16).

Automatic tuning is not possible.

• The local seek mode is set to “ON.”

t Set the local seek mode to “OFF” (page

11).

• The broadcast signal is too weak.

t Perform manual tuning.

The “ST” indication flashes.

• Tune in the frequency accurately.

• The broadcast signal is too weak.

t Set to the monaural reception mode (page

11).

A programme broadcast in stereo is heard

in monaural.

The unit is in monaural reception mode.

t Cancel monaural reception mode (page

11).

CD/MD playback

The sound skips.

Dirty or defective disc.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 75 76

Comments to this Manuals

No comments