Sony MDR-DS5000 Operations Instructions download pdf (Page 10)

Preparation

Rubber supports

To use on its side:

Place the digital surround processor so that the four rubber supports are on the

bottom.

Notes

• If the digital surround processor is placed on its side, the full infrared transmission range may

not be obtained for some installation conditions.

• Place the digital surround processor as shown in the illustration. Do not place the digital

surround processor on the side not having the rubber supports.

Connecting the digital surround processor with digital

components

Use the supplied optical digital connecting cable to connect the optical digital output

jack on a DVD player (or LD player), digital satellite tuner, or other digital component

to the DIGITAL IN jack of the digital surround processor.

To DIGITAL IN jack

Digital surround

processor

DVD player, LD player, digital

satellite tuner, or other digital

component having an optical

digital output jack

To optical digital

output jack

Optical digital connecting cable (supplied)

Take off the cap on the jack, match the orientation of the plug

with the jack, and then insert until the plug fits into place.

Notes

• The optical digital connecting cable is an extremely high-precision device and is sensitive to

jolts and external pressure. Therefore, be careful when inserting and removing the cable plug.

• This system is not compatible with the AC-3 RF jacks on LD players.

• The digital input for the digital surround processor does not support sampling frequencies of

96 kHz. Set the digital output setting for the DVD player at 48 kHz when using this system.

Noise may be heard when a 96-kHz digital signal is input.

• The digital input for the digital surround processor is not compatible with the DTS* format.

Noise may be heard when DTS-format signals are input.

* DTS is a trademark of Digital Theater Systems (USA).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 115 116

No comments

Sony MDR-DS5000 Operations Instructions Page 10