Sony FWD-S42E1 User Manual download pdf (Page 70)

Preparations for Using

the Network Functions

Installing an optional adaptor equipped with a

network terminal will make it possible to connect to

the network.

Also read the instruction manual of the optional

adaptor beforehand.

Precaution

For safety, connect the port of this display only to a

network where there is no danger of excessive voltage

or voltage surges.

Setting an IP address

When connected to a LAN, the IP addresses of the

display can be set using one of the following two

methods. Consult your network administrator

regarding details about IP address selection.

• Assigning a fixed IP address to the display

Normally this method should be used. Note that in

factory setting, the display is set to obtain an IP

address automatically.

• Automatically obtaining an IP address

If the network to which the display is connected has

a DHCP server, you can have the DHCP server

automatically assign an IP address. Note that in this

case the IP address may change every time the

display in which the display is installed is turned on.

Before setting the IP address, connect the LAN cable

to the display to establish the network. After about 30

seconds, turn on the display, and then start making the

desired settings.

Assigning a fixed IP address to the display

1 Press MENU button to bring up the main

menu.

2 Select “Setup” with F/f buttons and press

button.

3 Select “Advanced Setup” with F/f buttons

and press button.

4 Select “IP Address Setup” with F/f

buttons and press button.

5 Select “Manual” with F/f buttons and

press button.

6 Select an desired item to set from “IP

Address”, “Player IP Adress”*, “Subnet

Mask”, “Default Gateway”, “Primary DNS”,

“Secondary DNS” with F/f buttons and

press button.

* This can only be set when installing optional adaptor

BKM-FW55.

7 Set the three digit value (0 to 255) for each

of the four box with F/f buttons on the

display or numeric keys on the remote

control and press button or g button.

8 Set the three digit value (0 to 255) for each

of the four boxes and press button.

Repeat the same procedure as step 6 and

select the next desired item to set with F/f

buttons and press button.

9 After values are set for all the desired

items, select “Execute” with F/f buttons,

then press button.

Select “Execute” and press button. An IP address

is set manually.

When “Cancel” is selected, the setting will return to

the original setting.

Network Functions

1 ... 69 70 71 ... 255

Comments to this Manuals

No comments

Sony FWD-S42E1 User Manual Page 70

Comments to this Manuals

Related products and manuals for Monitors Sony FWD-S42E1