Sony MZ-N707 User Manual download pdf (Page 32)

32-GB

Adjusting the recording

level manually (Manual

Recording)

When you record, the sound level is

adjusted automatically. If necessary, you

can set the recording level manually

during both analog and digital recording.

This function can be set with the recorder

only.

1 While holding down X, press and

slide REC to the right.

The recorder stands by for recording.

2 Press MENU.

3 Press . or > repeatedly until

“RecVolume” flashes in the display,

and then press ENTER.

4 Press . or > repeatedly until

“ManualREC” flashes in the display,

and then press ENTER.

To switch back to the automatic

control, Press . or >

repeatedly until “Auto REC” flashes

in the display, and then press ENTER.

5 Play the source.

6 While observing the level meter in the

display, adjust the recording level by

pressing . or >.

Set the level so that the meter

segments light up around the fifth

segment (–12 dB) (the center of the

level meter) below the display

window.

If the sound is too high, lower the

recording level until the level meter

just barely reaches the ninth segment

(OVER) below the display window.

Recording does not start in this step.

If your source is an externally

connected component, be sure to cue

the source to the beginning of the

material to be recorded before you

start playback.

7 Press X again to start recording.

To stop recording

Press x. The recording level control is

switched back to automatic control when you

record the next time.

To switch back to automatic

level control

Select “Auto REC” in step 4.

REC

MENU

ENTER/./

>/X

ManualRec

<,

REC +

Volume

decreases

increases

–12 dB

OVER

1 ... 31 32 33 ... 240

Comments to this Manuals

No comments