Sony RM-VL1400T User Manual download pdf (Page 20)

Clearing programmed steps of a

Component Macro

If you make a mistake in programming steps or you want

to programme a new Component Macro, follow the

procedure below to clear the Component Macro.

1 While pressing the (light) button, press

the OTHER button.

“SET MODE” appears as the screen title.

2 Press the V/v buttons to select

“4 MACRO”, then press the OK button or

the centre Label select button.

“MACRO” appears as the screen title.

Tip

If a number is displayed before the menu, you can select the

menu by pressing the number button.

3 While pressing the COMPONENT select

button or Label select button on which the

Component Macro has been programmed,

press the (light) button.

A beep sounds and the Component Macro is cleared.

4 Press the (light) button or the RETURN

button twice.

The set mode closes, and the Remote Commander

returns to standby for operating the A/V components.

3 While pressing the SCROLL button, press

the COMPONENT select button or Label

select button to which the desired

Component Macro has been programmed.

“MACRO” and the selected A/V component name

appear on the first line and the programmed steps are

listed on the screen.

4 Press the V/v buttons so that the position

of the delay appears in the third line on the

screen, then press the SCROLL button.

Delay is added between the second line and the third

line on the screen, and “[DELAY]” appears in the

third line on the screen.

5 Press the OK button or centre Label select

button.

A beep sounds and programming is complete.

Press the (light) button or the RETURN

button twice.

The set mode closes, and the Remote Commander

returns to standby for operating the A/V components.

Notes

• If remote sensors of A/V components are too far apart from

each other, or they are covered, consecutive operation steps

programmed on a Component Macro may not be executed.

• If a Component Macro is not executed properly for any reason,

such as mentioned above, be sure to set all the A/V components

to the status before the Component Macro was executed.

Otherwise, A/V components will not work properly next time

the Component Macro is executed.

• Because some A/V components are designed to turn on/off

each time they receive the power on/off signal, those

components may not be turned on with the Component Macro.

Check the power on/off status of the A/V components before

using the Component Macro.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 179 180

Comments to this Manuals

No comments

Sony RM-VL1400T User Manual Page 20

Comments to this Manuals

Related products and manuals for Remote control Sony RM-VL1400T