Sony STR-DA5700ES User Manual Page 143

  • Download
  • Add to my manuals
  • Print
  • Page
    / 155
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 142
143
US
Additional Information
You may not make recordings using an
SCMS-compliant recording deck.
Copyright protection to prevent recording
is contained in the sources. In this case,
you may not be able to record from the
sources.
A test tone is not output from the
speakers.
• The speaker cords may not be connected
securely. Check to see if they are
connected securely and cannot be
disconnected by pulling on them slightly.
• The speaker cords may have the short-
circuit problem.
A test tone is output from a different
speaker than the speaker displayed on
the screen.
• The speaker configuration set up is
incorrect. Make sure that the speaker
connections and the configuration match
correctly.
The H.A.T.S. function does not work.
• “Audio Out” is set to “TV+AMP.” Select
“AMP” for “Audio Out.
The“H.A.T.S.” function may not work,
depending on the speaker pattern or
settings.
The FM reception is poor.
Use a 75-ohm coaxial cable (not supplied)
to connect the receiver to an outdoor FM
antenna (aerial) as shown on page 143. If
you connect the receiver to an outdoor
antenna (aerial), ground it against
lightning. To prevent a gas explosion, do
not connect the ground (earth) wire to a
gas pipe.
Radio stations cannot be tuned in.
Check that the antennas (aerials) are
connected securely. Adjust the antennas
(aerials) and connect an external antenna
(aerial), if necessary.
• Keep the satellite radio antenna, away
from the speaker cords and the power cord
to avoid picking up noise.
The signal strength of the stations is too
weak with automatic tuning. Use direct
tuning.
No stations have been preset or the preset
stations have been cleared (when tuning by
scanning preset stations is used). Preset the
stations (page 63).
Press DISPLAY MODE on the receiver so
that the frequency appears on the display
window.
The system cannot receive satellite
channels at all.
The receiving condition is not good. Move
the antenna to the place where the
condition is good.
Check that you subscribed to the desired
satellite radio service (page 64).
The USB device is not recognized.
• Turn off the receiver, then disconnect the
USB device. Turn on the receiver again
and reconnect the USB device.
Tuner
USB device
Receiver
To ground
Ground (earth)
wire (not supplied)
Outdoor FM antenna (aerial)
continued
Page view 142
1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 154 155

Comments to this Manuals

No comments