Sony STR-DA1ES User Manual download pdf (Page 59)

Additional Information

To connect an LD player via an RF demodulator

• Connect the LD player to the RF demodulator,

then connect the RF demodulator’s optical or

coaxial digital output to the receiver’s DVD/LD

OPTICAL IN or COAXIAL jack. When making

this connection, be sure to set INPUT MODE

manually (page 37). The receiver may not

operate correctly if INPUT MODE is set to

AUTO IN.

For details on DOLBY DIGITAL RF hookups,

see the operating instructions supplied with your

RF demodulator.

The FM reception is poor.

• Use a 75-ohm coaxial cable (not supplied) to

connect the receiver to an outdoor FM antenna as

shown below. If you connect the receiver to an

outdoor antenna, ground it against lightning. To

prevent a gas explosion, do not connect the

ground wire to a gas pipe.

Radio stations cannot be tuned in.

• Check that the antennas are connected securely.

Adjust the antennas and connect an external

antenna if necessary.

• The signal strength of the stations is too weak

(when tuning in with automatic tuning). Use

direct tuning.

• Make sure you set the tuning interval correctly

(when tuning in AM stations with direct tuning).

• No stations have been preset or the preset

stations have been cleared (when tuning by

scanning preset stations). Preset the stations

(page 27).

• Press DISPLAY so that the frequency appears in

the display.

RDS does not work.*

• Make sure that you’re tuned to an FM RDS

station.

• Select a stronger FM station.

The RDS information that you want does not

appear.*

• Contact the radio station and find out whether or

not they actually provide the service in question.

If so, the service may be temporarily out of

order.

There is no picture or an unclear picture appears

on the TV screen or monitor.

• Select the appropriate function on the receiver.

• Set your TV to the appropriate input mode.

• Move your TV away from the audio components.

Remote control

The remote does not function.

• Point the remote at the remote sensor on the

receiver.

• Remove any obstacles in the path between the

remote and the receiver.

• Replace all the batteries in the remote with new

ones, if they are weak.

• If the receiver’s COMMAND MODE and the

remote’s COMMAND MODE do not match,

transmission is not possible between the remote

and the receiver (page 41).

• Make sure you select the correct function on the

remote.

• When you operate a programmed non-Sony

component, the remote may not function

properly depending on the model and the make

of the component.

Reference sections for clearing the

memory

To clear See

All memorized settings page 20

Customized sound fields page 38

* Models of area code CEL, CEK only.

Outdoor FM antenna

Receiver

Ground wire

(not supplied)

To ground

COAXIAL

ANTENNA

75Ω

1 2 ... 54 55 56 57 58 59 60 61 62 63 64

Comments to this Manuals

No comments

Sony STR-DA1ES User Manual Page 59

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Sony STR-DA1ES