Sony STR-AV910 User Manual download pdf (Page 19)

Receiving Radio Broadcast Programs

Direct Tuning

1 Select the function TUNER.

2 Select FM or AM.

3 Press TUNING DIRECT.

4 Enter the frequency of the desired station by

pressing the appropriate numeric buttons.

The entered frequency is displayed.

Example 1-.FM 102.50 MHz Example2: AM ISSOkHz

I inpcn I I ! 1Q n

I U C .JI U UH2

I 1

________

i 3 3 U

5 Adjust the volume.

kHz

Tuning intenrals for direct tuning

FM: 50 kHz interval

AM; 10 kHz interval (changeable to the 9 kHz interval)

Changing the AM tuning intental

The AM tuning inten/al is preset to 10 kHz. To use the

receiver where the frequency allocation system is based

on the 9 kHz interval, make the following adjustments:

1 Turn on the power and tune in any AM station.

2 Press SYSTEM POWER to turn off the receiver.

3 Press again SYSTEM POWER to turn on the receiver

while pressing PRESET TUNING +.

Resetting the AM tuning intetvai

Follow the procedure for changing the AM tuning inten/al.

Caution

When the interval is changed, all preset stations which you

have memorized will be erased. After changing the inten/al,

be sure to newly preset stations. (See “Presetting Stations...,”

pages 20,21.)

When the entered number is not in the receivable frequency

range

The entered digits (up to 5 digits for FM or up to 3 digits for AM)

biink in the frequency display area, and reception does not take

place.

If this condition occurs, press TUNING DIRECT again, and enter

the correct frequency (the frequency range of the receiver is 87.50

to 108.0 MHz for FM, and 530 to 1710 kHz for AM).

Correcting the entered frequency

Repeat Steps 3 to 4 of Direct Tuning.

For entering AM frequencies, you need not enter the last “0”.

However, if you have changed the AM tuning interval to 9 kHz,

enter all the digits.

If you enter a frequency not covered by the tuning interval

The entered value is automatically rounded up or down to the

closest value covered by the tuning interval.

When an FM stereo program is noisy

When the unit receives an FM stereo program, the STEREO

indicator goes on in the display window. If the stereo program is

noisy, press FM MODE to change the mode over to MONO. This

eliminates the stereo effect, but the noise will be greatly reduced.

To return to the stereo mode, press FM MODE again.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 38 39

Comments to this Manuals

No comments

Sony STR-AV910 User Manual Page 19

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Sony STR-AV910