Sony DSC-P43 User Manual download pdf (Page 111)

111

Additional information

Precautions

Do not leave the camera in the

following places

• In extremely hot place, such as in a car

parked in the sun. The camera body may

become deformed or this may cause a

malfunction.

• Under direct sunlight or near a heater.

The camera body may become deformed

or this may cause a malfunction.

• On rocking vibration

• Near strong magnetic place

• On sandy or in dusty place

Do not let sand get into the camera. Sand

or dust may cause the camera to

malfunction and sometimes this

malfunction cannot be repaired.

Cleaning

Cleaning the LCD screen

Clean the screen surface with an LCD

cleaning kit (not supplied) to remove

fingerprints, dust, etc.

Cleaning the lens

Wipe the lens with a soft cloth to remove

fingerprints, dust, etc.

Cleaning the camera surface

Clean the camera surface with a soft cloth

slightly moistened with water, then wipe the

surface with a dry cloth. Do not use the

following as this may damage the finish or

the casing.

– Thinner, benzine, alcohol, disposable

cloth, or chemical such as insecticide

– Touch the camera with the above on your

hand

– Contact with rubber or vinyl for a long

time

Note on operating temperature

The camera is designed for use within a

temperature range of 0°C to 40°C (32°F to

104°F) (When using alkaline batteries: 5°C

to 40°C (41°F to 104°F)). Shooting in

extremely cold or hot locations that exceed

this range is not recommended.

On moisture condensation

If the camera is brought directly from a cold

to a warm location, or is placed in a very

damp room, moisture may condense inside

or outside the camera. This moisture

condensation may cause a malfunction of

the camera.

Moisture condensation occurs easily

when:

• The camera is brought from a cold

location such as a ski slope into a warmly

heated room.

• The camera is taken from an air-

conditioned room or car interior to the hot

outdoors, etc.

To prevent moisture condensation

When bringing the camera from a cold

place to a warm place, seal the camera in a

plastic bag and leave it in the new location

for about an hour. Remove the plastic bag

when the camera has adapted to the new

temperature.

If moisture condensation occurs

Turn off the camera and wait about an hour

for the moisture to evaporate. Note that if

you attempt to shoot with moisture

remaining inside the lens, you will be

unable to record clear images.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 123 124

Comments to this Manuals

No comments