Sony DVP-SR760HP User Manual download pdf (Page 8)

8

GB

Information

Troubleshooting

If you experience any of the following

difficulties while using the player, use this

troubleshooting guide to help remedy the

problem before requesting repairs. Should

any problem persist, consult your nearest

Sony dealer.

The power is not turned on.

c Check that the power cord (mains lead) is

connected securely.

There is no picture/picture noise appears.

c Re-connect the connecting cord securely.

c The connecting cords are damaged.

c Check the connection to your TV and switch

the input selector on your TV so that the signal

from the player appears on the TV screen.

c Change the colour system of the player

(page 5).

c Press [/1 to turn off the player, and enter

“369” using the number buttons on the remote,

then press [/1 to turn on the player again.

There is no sound.

c Re-connect the connecting cord securely.

c The connecting cord is damaged.

c The player is in pause mode or in Slow-motion

Play mode.

c The player is in fast forward or fast reverse

mode.

The remote does not function.

c The battery in the remote is weak.

c The remote is not pointed at the remote sensor

on the player.

c When you operate the player by pressing

buttons on the remote in sequence, press the

buttons within 5 seconds of each other.

The disc does not play.

c The disc is turned over.

Insert the disc with the playback side facing

down.

c The disc is skewed.

c The disc is dirty or flawed.

c The player cannot play certain discs.

c The region code on the DVD does not match

the player.

c Moisture has condensed inside the player.

AUDIO (HDMI): Selects the type of audio

signal output from the HDMI OUT jack. Set to

“PCM” if you connect the player to a TV that is

not compatible with DOLBY DIGITAL/DTS/

MPEG signals.

*

1

When you select “OTHERS t,” select and

enter a language code. See “LANGUAGE

CODE LIST” at the end of this manual.

*

2

This function affects the output from the

following jacks:

– LINE OUT L/R (AUDIO) jacks.

– DIGITAL OUT (COAXIAL)/HDMI OUT

jack only when “DOLBY DIGITAL” is set to

“D-PCM.”

*

3

If the picture does not appear normally or goes

blank, reset the setting. Press [/1 to turn off,

enter “369,” and then press [/1 to turn on the

player again.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Comments to this Manuals

No comments