Sony VPL-PX35 User Manual download pdf (Page 38)

GB

38

Maintenance

B Maintenance

Maintenance

When the lamp has burnt out or dims, or

“Please replace the LAMP.” appears on the

screen, replace the lamp with a new one. Use

LMP-P260 Projector Lamp as the

replacement lamp. The lamp life varies

depending on conditions of use.

When replacing the lamp after using

the projector

Turn off the projector, then unplug the

power cord.

Wait for at least an hour for the lamp to cool.

The lamp becomes a high temperature after

turning off the projector with the I / 1 key. If

you touch the lamp, you may scald your

finger. When you replace the lamp, wait for

at least an hour for the lamp to cool.

• If the lamp breaks, consult with qualified

Sony personnel.

• Pull out the lamp by holding the handle. If

you touch the lamp, you may be burned or

injured.

• When removing the lamp, make sure it

remains horizontal, then pull straight up. Do

not tilt the lamp. If you pull out the lamp

while tilted and if the lamp is broken, the

pieces may scatter, causing injury.

1 Place a protective sheet (cloth)

beneath the projector. Turn the

projector over so you can see its

underside.

Be sure that the projector is stable after

turning it over.

2 Open the lamp cover by loosening a

screw with the Phillips screwdriver.

For safety sake, do not loosen any other

screws.

3 Loosen the three screws on the lamp

unit with the Phillips screwdriver. Pull

out the lamp unit by the handle.

• The screws have washers. Do not

remove the screws, just loosen them.

Replacing the Lamp

Caution

Notes

Note

Note

Note

Handle

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 164 165

Comments to this Manuals

No comments