Sony R1880L User Manual download pdf (Page 29)

C L E A N I N G A N D C A R E

FAN

The fan will automatically start when heat rises from

range surface units or burners and when convection,

high mix, low mix or the broil settings are used. This

protects the microwave oven from excessive tem-

perature rise. The fan will stay on until the temperature

decreases. It cannot be turned off manually during

this time.

For other uses, select either high or low speed.

PRECAUTIONS FOR PROPER USE:

1. DO NOT leave range unattended while using high

temperatures. Automatic fan may start and provide

excessive air to the surface units. This may cause

spattering or boilover.

2. Avoid burning food.

3. Keep grease ﬁlters clean.

LIGHT

1. To replace light bulbs, ﬁrst disconnect power to the

oven at the circuit breaker panel or by unplugging.

2. To release cover remove the screw on the light cover.

(See illustration.)

3. Replace bulbs only with equivalent watt bulbs

available from a Sharp Authorized Servicer or parts

distributor. Bulbs are also available at most hardware

stores or lighting centers. DO NOT USE A BULB

LARGER THAN 30 WATTS.

4. Close light cover and secure with screw removed in

step 2.

CAUTION: Light cover may become very hot. Do not

touch glass when light is on. Do not use light for long

time use such as a night light.

Light cover

Screw

Light bulbs

CHARCOAL FILTER

Charcoal Filter, Sharp Part Number RK-220 is used for

Non-vented, recirculated installation. The ﬁlter should be

changed every 6 to 12 months depending on use.

1. Disconnect power to the oven at the circuit breaker

panel or by unplugging.

2. Remove 3 screws that secure louver.

3. Remove louver by inserting ﬂat edge screwdriver

over each tab pressing the tab down and moving

louver away from unit.

4. Pull the louver away from the oven.

5. Remove 2 screws that secure the sensor duct

cover.

6. Remove the sensor duct cover.

7. Remove old charcoal ﬁlter (if one is installed).

8. Slide new Charcoal Filter into position on the sup-

port tabs.

9. Reattach sensor duct cover and secure with 2

screws.

10. Push louver back into place and gently snap tabs

into place by hand (engaging both the bottom

and top tabs) and replace the 3 screws to secure

louver.

Sensor duct cover

Charcoal filter

1 2 ... 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

Sony R1880L User Manual Page 29

Comments to this Manuals