Sony LBT-XGV10AV User Manual download pdf (Page 21)

Tuner

Other Operations

Tune in a station with a

weak signal

Stop scanning

Change the preset

number

Change the preset station

Cancel presetting

To change the AM tuning interval

(Except for the Middle Eastern

model)

The AM tuning interval is factory-set to 9 kHz

(10 kHz in some areas). To change the AM

tuning interval, tune in any AM station first,

then turn off the system. While holding down

TUNER ENTER, press ?/1 to turn the system

back on. When you change the interval, all the

AM preset stations will be erased. To reset the

interval, repeat the same procedure.

Note

You cannot change the AM tuning interval in the

Power Saving Mode.

Tips

• The preset stations are retained for half a day even

if you unplug the power cord or if a power failure

occurs.

• To improve broadcast reception, reorient or move

the supplied antennas near a window or outdoors.

Do this

Follow the procedure

described in “Setting

presets through manual

tuning.”

Press TUNING MODE.

Start over from step 1.

Press TUNER MEMORY.

Listening to the radio

You can listen to a radio station either by

selecting a preset station, or by manually tuning

in the station.

Listening to a preset station

— Preset Tuning

Preset radio stations in the tuner's memory first

(see “Presetting radio stations” on page 20).

1 Press TUNER/BAND repeatedly to

select “FM” or “AM.”

2 Press TUNING MODE repeatedly until

“PRESET” appears.

3 Press TUNING –/+ repeatedly to select

the desired preset station.

Tip

You can also select the desired preset station by

pressing PRESET –/+ on the remote after step 1.

Listening to non-preset radio

station

— Manual Tuning

1 Press TUNER/BAND repeatedly to

select “FM” or “AM.”

2 Press TUNING MODE repeatedly until

“MANUAL” appears.

3 Press TUNING –/+ repeatedly to tune in

the desired station.

Tips

• To improve broadcast reception, adjust the supplied

antennas, or connect a commercially available

external antenna.

• When an FM stereo program has static noise, press

FM MODE repeatedly until “MONO” appears.

There will be no stereo effect, but the reception will

improve.

• Press TUNING MODE repeatedly until “AUTO”

appears in step 2 above, then press TUNING –/+.

The frequency indication changes and scanning

stops when the system tunes in a station (Automatic

Tuning).

• To record from the radio, see “Recording to a tape”

on page 23.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

Comments to this Manuals

No comments

Sony LBT-XGV10AV User Manual Page 21

Comments to this Manuals

Related products and manuals for CD players Sony LBT-XGV10AV