Sony D-T405 User Manual download pdf (Page 3)

D-T405.3-860-096-2X.E.U/CA2/E33/E92/AU

To resume playing from the point

you stopped the CD (Resume Play)

Normally, every time you stop and play,

playing starts from the beginning of the CD.

The resume play function, however, let you

listen to from the point at which you last

turned off the Discman.

Set RESUME to ON.

To cancel resume play, set RESUME to OFF.

Notes

• Even if RESUME is set to ON, playing starts

from the beginning when you open the lid.

• The resume point may be inaccurate by about

30 seconds.

To turn off the beep

You can turn off the beep that sounds as you

operate your Discman. (You cannot turn off

the beep that sounds during the radio

operation.)

Disconnect the power source (AC power

adaptor, rechargeable battery or alkaline

batteries). While you press and hold down p,

connect the power source again. To make the

beep sound again, disconnect the power

source, and then connect it without pressing

p.

Connecting to other

stereo equipment

You can listen to the CD through other stereo

equipment or record a CD on a cassette tape or

a MiniDisc. Refer to the instruction manual of

the other equipment for details. Before making

connections, turn off each piece of equipment.

Using the connecting cord

*If the OPTICAL (DIGITAL) IN jack is square-

shaped, use the POC-5AB optical digital

connecting cord instead.

Notes on connecting to other stereo

equipment

•Before you play the CD, turn down the volume

of the connected equipment so as not to

damage the connected speakers.

•The beep sound is not output from the

OPTICAL (DIGITAL)/LINE OUT jack.

•When you connect other equipment to the

OPTICAL (DIGITAL)/LINE OUT jack, you

cannot adjust the volume by this unit.

•When you record a CD on a cassette tape using

a tape recorder that has the blank search

function, release the ESP function. If the ESP

function is on, the blank search function does

not work.

Recording with optical digital

connection

Record a CD on a MiniDisc, DAT, etc., according

to the following procedure.

1 Press ^ on the Discman to start play.

2 Press ^ again to pause.

3 Press =/+ to select the track you want to

record.

4 Press r (record) on the MiniDisc recorder,

DAT recorder, etc.

5 Press ^ on the Discman to release pause.

Notes

•Connect the optical digital connecting cord

while the Discman is in stop mode.

If you make connection just after stopping the

Discman, optical signals may not be output.

•If you record without pausing the Discman,

some CD may have problem with recording the

first track number correctly.

•When you use digital equipment with your

Discman, use the AC power adaptor. If you use

a rechargeable battery or alkaline batteries, the

optical digital signal will not be output from

the Discman. (Unexpected phenomena may

occur, for instance, you cannot record a CD on

connected equipment.)

•MEGA BASS can be output from the

PHONES/REMOTE jack, but not from the

OPTICAL (DIGITAL )/LINE OUT jack.

•When you use an optical digital connecting

cord, the ESP function will be disabled.

Using the optical digital

connecting cord

MiniDisc recorder

DAT deck, etc.

OPTICAL

(DIGITAL) IN*

OPTICAL

(DIGITAL)/

LINE OUT

Continue to the reverse side m

Right (red)

Left (white)

LINE IN or

REC IN*

Stereo system,

cassette recorder,

radio cassette

recorder, etc.

Connecting cord

RK-G129HG

OPTICAL

(DIGITAL)/

LINE OUT

RESUME

ON OFF

Optical digital

connecting cord

POC-5B

(not supplied)

1 2 3 4 5 6

Comments to this Manuals

No comments