Sony XR-C33R User Manual download pdf (Page 25)

Troubleshooting guide

The following checklist will help you remedy the problems you may encounter with your unit.

Before going through the checklist below, check the connections and operating procedures.

General

Problem

No sound.

The contents of the memory

have been erased.

Indications do not appear

in the display.

Cause/Solution

•Cancel the ATT function.

•Set the fader control to the centre position for two-speaker

systems.

•Rotate the dial clockwise to adjust the volume.

• The power cord or battery has been disconnected.

• The reset button was pressed.

n Store again into the memory.

Remove the front panel and clean the connectors. See

“Cleaning the connectors” (page 23) for details.

Tape playback

Problem

The sound is distorted.

The AMS does not operate

correctly.

Cause/Solution

The tape head is contaminated.

n Clean the head with a commercially available dry-type

cleaning cassette.

• There is noise in the space between tracks.

• A blank space is too short (less than four seconds).

• The SEEK/AMS control was pushed up immediately before

the following track.

• The SEEK/AMS control was pushed down immediately after

the track starts.

• A long pause, or a passage of low frequencies or very low

sound level is treated as a blank space.

continue to next page n

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 131 132

No comments

Sony XR-C33R User Manual Page 25