Sony MEX-BT4000P Operations Instructions download pdf (Page 23)

23

If the device supports Bluetooth version

2.1, passkey input is not required.

* Passkey may be called “passcode,” “PIN

code,” “PIN number” or “Password,” etc.,

depending on the device.

This unit and the Bluetooth device

memorize each other’s information, and

when pairing is made, stays lit.

The unit is ready for connection to the

device.

Note

If “ ” continues to flash, the Bluetooth

device may not be compatible with this unit.

For details on compatible devices, visit the

support site on the back cover.

5 Select this unit on the Bluetooth device

to be connected.

“ ” or “ ” appears when the

connection is made.

Notes

• While connecting to a Bluetooth device, this

unit cannot be detected from another device.

To enable detection, enter the pairing mode and

search for this unit from another device.

• It may take time to search or connect.

• Depending on the device, the confirmation

display of the connection appears before

inputting the passkey.

• The time limit for inputting the passkey differs

depending on the device. If the time expires,

perform the pairing procedure from the

beginning again.

• This unit cannot be connected to a device that

supports only HSP (Head Set Profile).

Tip

Connection between this unit and the Bluetooth

device may be automatic, depending on the

device.

Cancelling pairing

Perform step 2 to cancel the pairing mode

after this unit and the Bluetooth device are

paired.

Connection

To use the device after pairing is made, start

the connection. Sometimes pairing allows

for connection automatically.

If pairing has already been achieved, start

operation from here.

Connecting a cellular phone

1 Press  and rotate the control

dial until “SET BT SIGNL” appears,

then press it.

“ ” lights up when Bluetooth signal is

activated.

Note

When the Bluetooth signal for this unit is

already ON, selecting “SET BT SIGNL”

deactivates the Bluetooth signal.

Tip

You can also output the Bluetooth signal from

this unit by pressing and holding  on

this unit more than two seconds.

Input passkey

“0000”

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 99 100

Comments to this Manuals

No comments