Sony TDM-NC1 User Manual download pdf (Page 32)

32

GB

By default the TDM-NC1 acquires an IP address

automatically. Use the following procedure to

specify an IP address, if necessary. Note that

when the TDM-NC1 is used in an environment

containing a router with DHCP, you should not

need to specify the IP address of the TDM-NC1.

1 Select “NET SETUP?” in the network

menu (page 31), then press ENTER.

2 Press . or > repeatedly until

“NET TYPE?” appears, then press

ENTER.

3 Press . or > repeatedly until

“MANUAL?” appears, then press

ENTER.

“IP ADDRESS?” appears.

4 Press ENTER again.

The currently set IP address appears.

5 Press . or > repeatedly to enter

the numeric values of the IP address.

Press m or M repeatedly to select the

digit that you want to set.

6 Press ENTER.

“SUBNET MASK?” appears.

7 Press ENTER again.

The currently set subnet mask appears.

8 Press . or > repeatedly to enter

the numeric values of the subnet mask.

Press m or M repeatedly to select the

digit that you want to set.

9 Press ENTER.

“GATEWAY?” appears.

10Press ENTER again.

The current default gateway appears.

11Press . or > repeatedly to enter

the numeric values of the default

gateway.

Press m or M repeatedly to select the

digit that you want to set.

12Press ENTER.

13Turn off the connected AV system with

DIGITAL MEDIA PORT interface (Sony

DAV series, etc.).

14Turn on the connected AV system.

To return to the automatic

setting

1 Select “NET SETUP?” in the network menu

(page 31), then press ENTER.

2 Press . or > repeatedly until “NET

TYPE?” appears, then press ENTER.

3 Press . or > repeatedly until “AUTO?”

appears, then press ENTER.

4 Turn off the connected AV system.

5 Turn on the connected AV system.

Select “RESTART?” in the network menu

(page 31), then press ENTER.

You can name the units for identification. After

naming a unit, the name will appear in the M-

crew Server.

1 Press MENU.

2 Press . / > until “NET SETUP?”

appears, then press ENTER.

3 Press . / > until “MY NAME?”

appears, then press ENTER.

4 Press . / > to select a desired

name from the preset names, then

press ENTER.

Tip

You can also create an original name. Refer to

“Additional Information” (page 37).

Making network settings

manually

Restarting the network

unit

Naming the unit

(My Name function)

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 466 467

Comments to this Manuals

No comments