Sony RS-232C User Manual download pdf (Page 29)

– 29 –

GROUP FADER : 43[H] 47[H] 46[H] 41[H],42[H] (‘CGFA,B’)

43[H] 47[H] 46[H] 31[H]-36[H] (‘CGF1-2’)

This command is used to set any desired single channel of the GROUP FADER.

Various setups can be memorized in the scene memories by specifying these scene Nos.

The commands that correspond to the respective channels are shown below.

• Packet format

43[H] 47[H] 46[H] 41[H] “parameter” 0D[H]

(In the case of MASTER A)

• Parameter

This parameter consists of the 13-byte data all the time in the order as shown in the table below.

When you specify NONE (30[H] ‘0’) as the scene No. in the 1st byte, you can establish the present setup.

When you specify the scene No.(31[H] (‘1’) to 44[H] (‘D’)), parameters of the subsequent 2nd to 13th bytes are written in the scene

memory.

• Scene No. (1st byte)

GROUP FADER Command

MASTER A 43[H] 47[H] 46[H] 41[H] ‘CGFA’

MASTER B 43[H] 47[H] 46[H] 42[H] ‘CGFB’

REMOTE 1 43[H] 47[H] 46[H] 31[H] ‘CGF1’

REMOTE 2 43[H] 47[H] 46[H] 32[H] ‘CGF2’

REMOTE 3 43[H] 47[H] 46[H] 33[H] ‘CGF3’

REMOTE 4 43[H] 47[H] 46[H] 34[H] ‘CGF4’

REMOTE 5 43[H] 47[H] 46[H] 35[H] ‘CGF5’

REMOTE 6 43[H] 47[H] 46[H] 36[H] ‘CGF6‘

byte Parameter name

1st SCENE No.

2nd-9th INDEX

10 th MIC INPUT FADER

11 th LINE INPUT FADER

12th LINE OUTPUT1-6 FADER

13th LINE OUTPUT7,8 FADER

SCENE No. SCENE No. SCENE No.

NONE 30[H] (‘0’) 7 37[H] (‘7’)14 3E[H] (‘>’)

131[H] (‘1’) 8 38[H] (‘8’)15 3F[H] (‘?’)

232[H] (‘2’)9 39[H] (‘9’)16 40[H] (‘@’)

333[H] (‘3’)10 3A[H] (‘:’)17 41[H] (‘A’)

434[H] (‘4’)11 3B[H] (‘;’)18 42[H] (‘B’)

535[H] (‘5’)12 3C[H] (‘<’)19 43[H] (‘C’)

636[H] (‘6’)13 3D[H] (‘=’)20 44[H] (‘D’)

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 61 62

No comments

Sony RS-232C User Manual Page 29