Sony HT-NT3 User Manual download pdf (Page 40)

40

GB

HT-NT3

4-559-516-15(1)

D:\NORM'S JOB\SONY HA\SO150038\HT-NT3 (PMRF 06)\4559516151_GB

(CEK)\070ADD.fm

masterpage: Left

Notes on updating

This system allows you to update the

software automatically when connected

to the Internet via a wired or wireless

network.

You can add new features and use the

system with more convenience and

safety by updating the system.

If you do not want to update

automatically, you can disable the

function by using SongPal installed on

your smartphone or tablet. However,

the system may update the software

automatically for reasons such as

safety, even if this function is disabled.

You can also update the software using

the settings menu when this function is

disabled. See “Using the Setup Display”

(page 21) for details.

You may not use the system while the

software is being updated.

Disclaimer regarding services

offered by third parties

Services offered by third parties may be

changed, suspended, or terminated

without prior notice. Sony shall not be

held responsible in these situations.

If you have any questions or problems

concerning your system, please consult

your nearest Sony dealer.

Troubleshooting

If you experience any of the following

difficulties while using the system, use

this troubleshooting guide to help

remedy the problem before requesting

repairs. Should any problem persist,

consult your nearest Sony dealer.

In the event of a problem with the

wireless sound function, have a Sony

dealer check the entire system (Bar

Speaker and subwoofer).

The power does not turn on.

 Check that the AC power cord

(mains lead) is connected securely.

The remote control does not function.

 The distance between the remote

control and the Bar Speaker is too

far.

 The batteries in the remote control

are weak.

The system is turned off automatically.

 The [Auto Standby] is working. Set

[Auto Standby] to [Off] (page 26).

The system does not work normally.

 Disconnect the AC power cord

(mains lead) from the wall outlet

(mains), then reconnect after

several minutes.

TV remote control does not work.

 This problem might be solved by

enabling the IR repeater function

(page 35).

Sensors of the TV do not work properly.

 The Bar Speaker may block some

sensors (such as the brightness

sensor) and the remote control

receiver of your TV, or the “emitter

for 3D glasses (infrared

transmission)” of a 3D TV that

supports the infrared 3D glass

system. Move the Bar Speaker away

from the TV within a range that

allow those parts to operate

properly. For the locations of the

sensors and remote control

receiver, refer to the operating

instructions supplied with the TV.

General

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 63 64

Comments to this Manuals

No comments