Sony KDL-40XBR7 User Manual download pdf (Page 25)

Operating the TV

Programming the Remote

Control

The remote control can be programmed to operate

other equipment and is pre-programmed to operate

the following Sony equipment.

Follow the steps below to program your TV

remote control.

1 Find the code that corresponds to your

equipment from page 26. If more than one

code is provided, try programming the first

code listed.

2 Press and hold DVD, AMP or STB

simultaneously with the INPUT button and

release. When in the programming mode, the

FUNCTION button blinks for approximately

30 seconds until a code is entered.

3 Enter the five digit code using 0-9 while the

FUNCTION button is lit. If the code is not

entered within 30 seconds, you must repeat

step 2.

4 Press or ENT to confirm the code. If

successfully programmed, the FUNCTION

button blinks twice; if not, it blinks five times.

• Any of the FUNCTION buttons can be programmed to

operate other equipment regardless of the labeling. For

example, DVD can be programmed to operate a Blu-

ray player.

Confirm the Programming

If you can turn your equipment on and off using

the green POWER button, the programming is

complete. If not, try the next code listed.

• In some cases, you may not be able to program your

remote control. If this is the case, use your equipment’s

own remote control.

The backlight can be set to light up when a button

is pressed.

To set backlight:

Press LIGHT and MUTING simultaneously until

the four FUNCTION buttons blink red.

To turn off backlight:

Press LIGHT and MUTING until the TV button

blinks red.

The remote control can be set to remain lit longer

than the default time setting of approximately five

seconds with the FUNCTION buttons.

To change backlight time setting:

1 Press LIGHT, VOL+, and then CH+

simultaneously until the FUNCTION button

blinks red.

Select the

FUNCTION

button that corresponds

to your preferred time out setting and press

To reset the remote control to the factory default

settings, press SOUND, TV POWER, and then

. The FUNCTION buttons blink red

simultaneously when successfully reset.

Function Button Sony Equipment Code Number

DVD DVD Player 31033

AMP Receiver 52172

STB Digital Satellite 01639

Programming Other Equipment

DISPLAY

VOL CH

DVD AMP STB TV

PREV REPLAY ADVANCE NEXT

THEATER SOUND PICTURE WIDE

CC FREEZE

LIGHT POWER

TV POWER

SYNC MENU PAUSE

PLAY

FUNCTION

STOP

Auto Backlight

Backlight Time Out

DVD 5 seconds (default) AMP 10 seconds

STB 15 seconds TV 20 seconds

Reset the Remote Control

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 62 63

Comments to this Manuals

No comments

Sony KDL-40XBR7 User Manual Page 25

Comments to this Manuals

Related products and manuals for Televisions Sony KDL-40XBR7