Sony KDF-E60A20 User Manual download pdf (Page 35)

Connecting the TV

KDF-E55/60A20

2-593-962-11(3)

VCR and Cable Box Use this hookup if:

❑ Your cable TV company scrambles some channels, but not all of them

(pay channels vs. regular cable channels) and you need to use a cable

box.

With this setup you can:

❑ Use the TV’s remote control to change channels on your cable box

when the signal is scrambled. To program your Sony remote control to

operate your cable box, see “Programming the Remote Control” on

page 44.

❑ Use the TV’s remote control to change channels on your TV when the

signal is not scrambled. Your TV’s tuner provides a better picture

quality than the output of your cable box.

Disconnect all power sources before making any connections.

1 Connect the CATV cable to the single (input) jack of the splitter.

2 Use a coaxial cable to connect one of the splitter’s two output jacks to

the TV’s CABLE jack.

3 Use a coaxial cable to connect the splitter’s other output jack to the

cable box’s input jack.

4 Use a coaxial cable to connect the cable box’s output jack to the VCR’s

RF input jack.

5 Use an A/V cable to connect the cable box’s A/V output jacks to the

TV’s A/V input jacks.

Use an A/V and S VIDEO cables to connect the VCR’s AUDIO and

S VIDEO OUT jacks to the TV’s AUDIO and S VIDEO IN input

jacks.

7 Run Auto Program, as described in “Setting Up the TV Channel List”

on page 30.

Before connecting a

cable box, see “Using

CableCARD Device” on

page 25.

✍ To view scrambled channels, tune the TV to the channel the cable box is

set to (usually channel 3 or 4) and then use the cable box to switch

channels.

(Continued)

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 91 92

No comments

Sony KDF-E60A20 User Manual Page 35