Sony SAT-B65A User Manual download pdf (Page 15)

Adding system components 7

Adding system components 2

You can configure your DIRECTV

Receiver several ways depending on the

additional audio/video components you want to use.

This chapter explains how to:

• Connect a terrestrial (broadcast) TV antenna (this page).

• Connect the optional RF remote control antenna (this page).

• Connect and set-up a VCR (see page 8).

• Integrate the DIRECTV Receiver into your existing audio or A/V system

(see page 10).

Connecting

components

At this point, you should have:

Connect a terrestrial

antenna

You can connect a terrestrial (broadcast) TV antenna to your DIRECTV

Receiver by connecting it to the DIRECTV Receiver’s

TV ANT/CABLE IN jack

(refer to figures on page 2). The remote control

INPUT button allows you to

switch between DIRECTV

programming and input from the terrestrial

antenna.

Connect the RF remote

control antenna

(SAT-A65A only)

The SAT-A65A DIRECTV Receiver uses an optional RF (radio frequency)

remote control antenna that allows you to control your receiver from other

rooms in your house.

1. Plug the RF remote control cable into the

RF REMOTE connector on the

DIRECTV Receiver rear panel (refer to figures on page 2.)

2. Extend the cable and place the antenna in the desired location

To achieve the best operating range from the remote control, position the

antenna as high and as far away from metal objects as possible.

Verified that your system is operating properly.

Connected your DIRECTV Receiver to your TV.

Unplugged all components from electrical outlets.

RF Antenna

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 59 60

No comments

Sony SAT-B65A User Manual Page 15