Sony RM-VL600 User Manual download pdf (Page 37)

Troubleshooting

If you have problems setting up or using the Remote Commander, first

check the batteries (page 8), then check the items below.

Remedy

• Move closer to the component. The maximum operating

distance is approximately 32.8 ft. (10 m).

• Check that you are aiming the Commander directly at the

component, and that there are no obstructions between the

Commander and the component.

• Power on the components first, if necessary.

• Make sure you have pressed the correct Component Select

button. In case of CBL or DVD, make sure the desired

component is selected.

• Check that the component has infrared remote capability. For

example, if your component didn’t come with a remote

commander, it probably isn’t capable of being controlled by a

remote commander.

• You have assigned a different component to the Component

Select button. Check the component assigned to that button

and the component code.

• If your visual components are connected to an audio system,

make sure you have set up the Commander as described in

“Controlling the Volume of Visual Components Connected to

an Audio System” (page 25).

• You have assigned another component on the TV or AMP

button (page 33). In this case, the volume cannot be controlled

when you select components other than a TV or AMP.

• Batteries are weakened.

Replace them with new ones.

• Set the component code correctly. If the code that is listed first

for your component does not work, try all the codes for your

component in the order in which they are listed in the

supplied “Component Code Numbers.”

• Some features may not be preset. If some or all of the buttons

do not function correctly even after you have set the

component codes, then use the Learning function to program

the remote control signals for the component (page 16).

• The component may be operated with a code number that is

not listed in the “Component code numbers”. See “Setting a

Component Code by the Search Function” (page 13) and try

setting a code number again with the Search function.

• When you teach signals of an interactive signal exchange

system remote control unit (supplied with some of Sony’s

amplifiers) to the Commander, the response signal of the

main unit may interfere with the learning of the Commander.

In such a case, move to a place where the signals will not

reach the main unit (e.g., another room, etc.).

• Make sure that the Remote Commander has “learned” the

correct signals. If not, see “For accurate Learning” (page 19)

and try the Learning procedure again (page 16).

Symptom

You cannot operate

components.

You cannot control the

volume.

The Component Select

buttons flash by a

constant interval when

you press a button.

You cannot operate a

component even after

setting the component

code numbers.

The Commander fails to

learn the remote control

signals.

You cannot operate a

component even after

you programmed the

remote control signals

with the Learning

function.

Continued

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 51 52

Comments to this Manuals

No comments

Sony RM-VL600 User Manual Page 37

Comments to this Manuals

Related products and manuals for Remote controls Sony RM-VL600