Sony S2 User Manual download pdf (Page 62)

Messages

If the following messages flash in the display window, check the messages below.

Error message Meaning/Remedy

BLANK • An MD with no recording on it is inserted.

BUSY • You tried to operate the recorder while it was accessing the recorded

data.

, Wait until the message goes out (in rare cases, it may take a few

minutes).

Saving • The MD player is recording information (sounds) from the memory

to the disc.

, Wait until this process is completed. Do not expose the player to

any physical shock, nor disrupt power supply.

ERROR • Recording was not correctly done.

, Place the recorder at a place with no vibrations and record again.

• The disc is soiled with an oil film or finger prints, is scratched, or is

not a standard disc.

, Try recording again with another disc.

• The recorder cannot read the disc information correctly.

, Reinsert the disc.

• The recorder cannot read the disc information correctly.

, Insert another disc.

, If it is no problem to erase the entire disc, do so (page 44).

FULL • The remaining recording time on the disc is 12 seconds (stereo), 24

seconds (LP2 stereo or monaural), 36 seconds (LP4 stereo), or less.

, Replace the disc.

HiDCin • Voltage of the power supply is too high (The supplied AC power

adaptor or the recommended car battery cord is not used).

, Use the supplied AC power adaptor or the recommended car

battery cord.

HOLD • The recorder is locked.

, Slide HOLD against the arrow to unlock the recorder (page 16,

47).

LoBATT • Battery is weak.

, Replace the dry battery (page 15).

MEMORY • You tried to record with the recorder placed where it receives

continuous vibration.

, Put the recorder on a stable place, and start recording again.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 107 108

No comments

Sony S2 User Manual Page 62