Sony TC-WR545 User Manual

3-758-385-22(1)StereoCassette DeckOperating instructionsTC-WR545/WR741® 1994 by Sony Corporation

The Auto Play function automatically starts playing back a cassette after fastwinding it to the beginning.While holding down or <1, press o

Press SET to program a selection.The program number increases by one and the specified selection is programmed.To program the same selection repeatedl

uiapiertf itecoraingRecording (Only on Deck B)Follow this procedure to record a source on a cassette (deck B only).Insert a cassette into deck B.Wind

Adjusting the Recording LevelThe proper recording level, which differs according to the tape type, is indicated on the peak level meter for each tape

Automatic Bias Current and Recording Level Calibration (TC-WR545 Only)Though the Automatic Tape Selection (ATS) system in your unit automatically sets

Inserting a Blank Space During Recording — Record MutingNotes•Since the unit records a test tone on the tape during automatic calibration, recorded ma

J Chapter 4 Other OperationsDubbing a TapeUse the dubbing function to copy a tape in deck A to a tape in deck B. High-speed dubbing is convenient for

Dubbing Only Specific PortionsFollow this procedure to dub only specific portions of selections. Note that this is only possible in the normal-speed d

Dubbing Selections in a Specified Order — RMS Dubbing (TC-VVR545 only)Follow this procedure to dub selections being played back from an RMS program. N

MaintenanceCleaning the Heads and Tape Path Demagnetizing the HeadsClean all surfaces over which the tape travels after every ten hours of operation t

WARNINGOwner's RecordThe model and serial numbers are located on the rear of the unit. Record the serial number in the space provided below. Refe

SpecificationsRecording system Fast winding time4-track 2-channel stereo Approx. 90 sec. (with Sony C-60 cassette)Bias AC biasSignal-to-noise ratio (

Troubleshooting GuideThe following trouble checks will help you correct the most common problems encountered with your tape deck. Should any problems

Chapter 1 Getting StartedTable of Contents FeaturesChapter 1 Getting StartedFeatures...

Precautions UnpackingOn safety•Should any solid object or liquid fall into the cabinet, unplug the unit and have it checked by qualified personnel bef

Hooking Up the SystemBefore You Begin•Turn off the power to all equipment to be connected before making any connection.•Note that the red plug of the

Identifying the Parts on the Front Panel(The illustration shows the TC-WR545.)For details, refer to the page number(s) indicated in parentheses.Q] POW

Playing BackFollow the procedure below to play back a cassette on deck A or B.4 3Turn on the amplifier and select the tape function.Insert a ca

Playing Back Both Decks in Succession — Relay PlayThe Relay Play function pla)rs back cassettes in deck A and deck B continuously and in consecutive o

Locating a Selection — Multi-AMS (Automatic Music Sensor)Through its ability to detect the blank space between selections, the Multi-AMS function allo