Connections
If your car has no accessory position on the ignition key switch
— POWER SELECT switch
The illumination on the front panel is factory set to be turned on even when the unit is not being played.
However, this setting may cause some car battery wear if your car has no accessory position on the
ignition key switch. To avoid this battery wear, set the POWER SELECT switch located on the bottom
of the unit to the B position, then press the reset button. The illumination is reset to stay off while the
unit is not being played.
Note
The caution alarm for the front panel is not activated when the POWER SELECT switch is set to the B position.
Change the position with a jeweler’s screwdriver, etc.
Reset Button
When the installation and connections are complete, be sure to press the reset button with a ball-point pen
etc.
Reset button
Caution
• This unit is designed for negative earth 12 V DC operation only.
• Before making connections, disconnect the earth terminal of the car battery to avoid short circuits.
• Connect the yellow and red power input leads only after all other leads have been connected.
• Be sure to connect the red power input lead to the positive 12 V power terminal which is energized
when the ignition key is in the accessory position.
• Run all earth wires to a common earth point.
• Connect the yellow cord to a free car circuit rated higher than the unit’s fuse rating. If you connect this
unit in series with other stereo components, the car circuit they are connected to must be rated higher
than the sum of the individual components’ fuse rating. If there are no car circuits rated as high as the
unit’s fuse rating, connect the unit directly to the battery. If no car circuits are available for connecting
this unit, connect the unit to a car circuit rated higher than the unit’s fuse rating in such a way that if the
unit blows its fuse, no other circuits will be cut off.
Connection Diagram
Example 1
Example 2
REAR
LINE OUT
CD/MD unit
Source selector
CD/MD unit
Front speakers
Front speakers
Rear speakers
Rear speakers
Power amplifier
Power amplifier
XR-C8200
BUS
AUDIO IN
FRONT
LINE OUT
BUS
CONTROL IN
BUS AUDIO IN
BUS CONTROL IN
XR-C8200
CD/MD unit
Front speakers
Rear speakers
If you connect an optional power amplifier and do not use the built-in amplifier, the beep-tone will be disabled.
For connecting two or more changers, the source selector XA-C30 (optional) is necessary.
When you change the position of the switch, be sure to press the reset button after the connections are completed.
(4 pages)
(2 pages)
(4 pages)
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals