Sony SDM-X202 User Manual

4-093-820-01(3)© 2002 Sony CorporationTFT LCD ColorComputer DisplayOperating Instructions USD:\##sagyou \#07 July\0730\4087260131\4087260131\01COV-SDM

10If no picture appears on your screen• Check that the power cord and the video signal cable are properly connected.• If “No input signal” appears on

11GBSelecting the input signal (INPUT button)Press the INPUT button.The input signal and corresponding input indicator change each time you press this

12Customizing Your MonitorYou can make numerous adjustments to your monitor using the on-screen menu.Navigating the menu1 Display the main menu.Press

13GB PICTURE ADJUSTMENT menuYou can adjust the following items using the PICTURE ADJUSTMENT menu.• Backlight•Contrast•Brightness•Color•Gamma• Smoothin

14Fine tuning the color temperatureThe setting is stored in memory for INPUT1, INPUT2 (DVI-D), and INPUT2 (HD15), respectively.1 Press the MENU button

15GB INPUT SETTING menuYou can adjust the following items using the INPUT SETTING menu.•Auto Adjust•Phase•Pitch•H Center•V Center• Input2 Priorityx Ad

16Adjust the picture’s position manually (H Center /V Center)If the picture is not in the center of the screen, adjust the picture’s centering as foll

17GB OPTION menuYou can adjust the following items using the OPTION menu.•Zoom• Menu Position• Audio Select• USB Select•Language• Menu Lock•Reset1 Pre

18x Language1 Press the M/m buttons to select “Language” and press the OK button.The options are displayed on the popup menu. 2 Press the M/m buttons

19GBPower saving functionThis monitor meets the power-saving guidelines set by VESA, ENERGY STAR, and NUTEK. If the monitor is connected to a computer

2Owner’s RecordThe model and serial numbers are located at the rear of the unit. Record these numbers in the spaces provided below. Refer to them when

20TroubleshootingBefore contacting technical support, refer to this section.On-screen messagesIf there is something wrong with the input signal, one o

21GBTrouble symptoms and remediesIf a problem occurs as a result of a connected computer or other equipment, refer to the connected computer/equipment

22Picture flickers, bounces, oscillates, or is scrambled.• Adjust the pitch and phase (analog RGB signal only) (page 15).• Isolate and eliminate any p

23GBDisplaying this monitor’s informationWhile the monitor is receiving a video signal, press and hold the MENU button for more than 5 seconds until t

24SpecificationsLCD panel Panel type: a-Si TFT Active MatrixPicture size: 20.1 inchInput signal format RGB operating frequency*Horizontal:28–92 kHz (a

3Table of ContentsGB• Macintosh is a trademark licensed to Apple Computer, Inc., registered in the U.S.A. and other countries.• Windows is registered

4PrecautionsWarning on power connections• Use the supplied power cord. If you use a different power cord, be sure that it is compatible with your loca

5GBIdentifying parts and controlsSee the pages in parentheses for further details.A 1 (Power) switch and 1 (power) indicator (pages 9, 19, 23)This swi

6Rear of the LCD displayK AC IN connector (page 8)This connector connects the power cord (supplied).L Security Lock HoleThe security lock hole should

7GBSetupBefore using your monitor, check that the following items are included in your carton:•LCD display• Power cord• HD15-HD15 video signal cable (

82 Using the supplied HD15-HD15 video signal cable (analog RGB), connect the computer to the monitor’s HD 15 input connector (analog RGB) for INPUT 1

9GBSetup 5:Bundle the cords and cables1 Remove the arm cover.2 Secure the video signal cable and audio cord using the cable holder on the cabinet.3 Bu