4
GB
Start-up Guide
Checking the
accessories
Stand (1)
Fixing screws for Table-Top Stand (M5 ×
16) (3)
Remote RM-GA022 (1)
Size AA batteries (R6 type) (2)
x To insert batteries into the remote
1: Attaching the
stand
1 Place the TV with its screen facing down on a
level and stable surface covered with a thick
and soft cloth.
2 Fix the TV to the Stand using the supplied
screws. The arrow marks indicate the
location of the screw holes used for securing
the Stand.
• Observe the correct polarity when inserting
batteries.
• Do not use different types of batteries together
or mix old and new batteries.
• Dispose of batteries in an environmentally
friendly way. Certain regions may regulate the
disposal of batteries. Please consult your local
authority.
• Handle the remote with care. Do not drop or
step on it, or spill liquid of any kind onto it.
• Do not place the remote in a location near a heat
source, a place subject to direct sunlight, or a
damp room.
• Refer to the supplied Stand leaflet for proper
attachment.
• For best picture quality, do not expose the
screen to direct illumination or sunlight.
Push to
open
• Be careful not to hit the Stand against the edge
of the surface when attaching it.
• Hold the Stand with one hand to avoid it
dropping when attaching.
• Fix the TV to the stand according to the arrow
marks that guide the screw holes using the
supplied screws.
• Two people are needed to transport this TV set.
• If using an electric screwdriver, set the
tightening torque at approximately 1.5 N·m {15
kgf·cm}.
• Keep the TV in a horizontal position while
tightening the screws. Be sure to securely
tighten the supplied screws, otherwise the TV
may fall down.
• Use an appropriate screwdriver to attach the
screws tightly without damaging the screw
head.
• Please ensure the AC power cord (mains lead)
is away from the stand installation location when
you attach below stand.
• Do not touch the inner side of the bottom of the
TV stand to avoid being hurt.
Thick and
soft cloth
Comments to this Manuals