Sony PCG-SR7K User Manual download pdf (Page 4)

Regulatory Information

If you have any questions about this

product, you can reach the Sony

Customer Information Service Center

at 1-888-4SONYPC; or write to the

Sony Customer Information Service

Center at 12451 Gateway Blvd., Ft.

Meyers, FL 33913, or find Sony

Customer Service on the Web at:

http://www.sony.com/pcsupport.

The number below is for FCC-related

matters only.

This equipment has been tested and found

to comply with the limits for a Class B

digital device, pursuant to Part 15 of the

Rules. These limits are designed to provide

reasonable protection against harmful

interference in a residential installation.

This equipment generates, uses, and can

radiate radio frequency energy and, if not

installed and used in accordance with the

instructions, may cause harmful

interference to radio communications.

However, there is no guarantee that

interference will not occur in a particular

installation. If this equipment does cause

harmful interference to radio or television

reception, which can be determined by

turning the equipment off and on, the user

is encouraged to try to correct the

interference by one or more of the

following measures:

❏

Reorient or relocate the receiving

antenna.

❏

Increase the separation between the

equipment and the receiver.

❏

Connect the equipment into an outlet

on a circuit different from that to

which the receiver is connected.

❏

Consult the dealer or an experienced

radio/TV technician for help.

You are cautioned that any changes or

modifications not expressly approved in

this manual could void your authority to

operate this equipment.

Only peripherals (computer input/output

devices, terminals, printers, etc.) that

comply with FCC Class B limits may be

attached to this computer product.

Operation with noncompliant peripherals

is likely to result in interference to radio

and television reception.

All cables used to connect peripherals must

be shielded and grounded. Operation with

cables, connected to peripherals, that are

not shielded and grounded, may result in

interference to radio and television

reception.

FCC Part 68

This equipment complies with Part 68 of

the FCC rules. On the bottom of this

equipment is a label that contains, among

other information, the FCC Ringer

Equivalence Number (REN) for this

equipment. If requested, this information

must be provided to the telephone

company.

This modem uses the USOC RJ-11

telephone jack.

The REN is used to determine the quantity

of devices which may be connected to the

telephone line. Excessive RENs on the

telephone line may result in the devices not

ringing in response to an incoming call. In

most, but not all areas, the sum of the RENs

should not exceed five (5.0). To be certain

of the number of devices that may be

Declaration of Conformity

Trade Name: SONY

Model No.: PCG-3102/PCG-3112

Responsible Party: Sony Electronics Inc.

Address: 1 Sony Drive

Park Ridge, NJ 07656

Telephone: 201-930-6972

This device complies with Part 15 of the FCC rules.

Operation is subject to the following two

conditions:

(1) This device may not cause harmful

interference, and

(2) this device must accept any interference

received, including interference that may cause

undesired operation.

1 2 3 4 5 6 7 8 9 ... 109 110

Comments to this Manuals

No comments