Sony PCV-RS100 Instruction Manual download pdf (Page 2)

PCV-RS Series Hard Disk Drive

Replacement Instructions

P/N T99860136 Rev. C 2/2

Ensure that all 4 holes (2 on each

side) are in alignment

Step 4. Proceed to disconnect the IDE Cable [1] and Power

Cable [2] from the Hard Drive. IMPORTANT! Some force may be

required to initiate the removal of the cables. Take caution not to

damage the cables. Pull with equal force on both sides of each

cable to remove them as shown above.

Step 5. Using the enclosed magnetic screwdriver, remove

the marked screw as shown on the picture. With one hand hold

the bracket enclosure while pulling the complete assembly out

of the unit.

Step 6. Using the enclosed magnetic screwdriver, remove the

four (4) screws that secure the Hard Drive into the bracket

enclosure. IMPORTANT! Before proceeding, take note of original

position of the Drive inside the bracket. Slide out the original drive.

Step 7. Slide New Hard drive inside bracket with all holes in

alignment. Reinstall the four (4) screws previously removed,

securing new drive into the bracket.

Step 8. [A] Reinstall the bracket enclosure being careful to

align the guides. Hold the bracket in place and reinstall the screw

previously removed. [B] Proceed to Reconnect the Hard Drive

cables into their original position.

Step 9. Lower the cover onto the unit, Ensure that tabs on

the bottom edge into the base of your computer. Compress

both sides of the cover and push forward while holding the front

of your computer. Reinstall the three (3) screws removed in

step 1.

Align tabs

on both sides of

cover

[B]

[A]

[1]

[2]

Remove

screw

1 2

No comments

Sony PCV-RS100 Instruction Manual Page 2