Sony DVS-9000-C User Manual download pdf (Page 17)

1-9

DVS-9000/9000SF

1-5. Rack Mounting

2. Rack Mounting Procedure

This section describes the rack mounting procedure using

the RMM-10 rack mount kit.

Tighten the screws to the following torque.

Tightening torque : 120 x 10

N.m {12.2 kgf.cm}

1. Attach the rack tool to the side of the equipment using

the specified six screws.

Use B4 x 6 screws.

B4 x 6

Rack tool

2. Loosen the screws on the rear of the right and left

adapters and adjust the length of the adapter according

to the depth of the rack.

(The illustration below shows the left adapter.)

Maximum depth of adapter : 750 mm

Minimum depth of adapter : 595 mm

3. Attach the right and left adapters to the rack complete-

ly using the specified six screws.

(The illustration below shows the left adapter.)

4. Tighten the screws (B4 x 6 : two screws each on the

right and left) for adjusting the length of the adapter

completely (the screws that were loosened in step 2).

5. Remove the front panel of the equipment.

(Refer to Section 1-4-1.)

B4 x 6

Portion of

the rail

Adapter

B4 x 10

31.75

Unit : mm

(The illustration shows the DVS-9000.)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 41 42

No comments

Sony DVS-9000-C User Manual Page 17