Sony CDX-G2050UI User Manual download pdf (Page 16)

16GB

Troubleshooting

The following checklist will help you remedy

problems you may encounter with your unit.

Before going through the checklist below,

check the connection and operating

procedures.

For details on using the fuse and removing

the unit from the dashboard, refer to the

installation/connections manual supplied

with this unit.

If the problem is not solved, visit the support

site (page 18).

General

No power is being supplied to the unit.

 If the unit is turned off and the display

disappears, the unit cannot be operated with

the remote commander.

 Turn on the unit.

No sound.

 The position of the fader control [FADER] is

not set for a 2-speaker system.

No beep sound.

 An optional power amplifier is connected and

you are not using the built-in amplifier.

The contents of the memory have been

erased.

 The power supply lead or battery has been

disconnected or not connected properly.

Stored stations and correct time are erased.

The fuse has blown.

Makes a noise when the position of the

ignition is switched.

 The leads are not matched correctly with the

car’s accessory power connector.

During playback or reception, the

demonstration mode starts.

 If no operation is performed for 5 minutes

with [DEMO-ON] set, the demonstration

mode starts.

 Set [DEMO-OFF] (page 12).

The display disappears from/does not appear

in the display window.

 The dimmer is set to [DIM-ON] (page 12).

 The display disappears if you press and hold

OFF.

 Press OFF on the unit until the display

appears.

 The connectors are dirty (page 14).

The display disappears while the unit is

operating.

 The Black Out function is set to on (page 12).

The operation buttons do not function.

The disc will not eject.

 Press DSPL and (back)/MODE for more

than 2 seconds to reset the unit.

The contents stored in memory are erased.

For your safety, do not reset the unit while

you are driving.

Radio reception

Stations cannot be received.

The sound is hampered by noises.

 The connection is not correct.

 If your car has built-in radio antenna

(aerial) in the rear/side glass, connect an

REM OUT lead (blue/white striped) or

accessory power supply lead (red) to the

power supply lead of a car’s antenna

(aerial) booster.

 Check the connection of the car antenna

(aerial).

 If the auto antenna (aerial) will not extend,

check the connection of the power

antenna (aerial) control lead.

Preset tuning is not possible.

 The broadcast signal is too weak.

RDS

PTY displays [- - - - - - - -].

 The current station is not an RDS station.

 RDS data has not been received.

 The station does not specify the program

type.

1 ... 15 16 17 ... 56

Comments to this Manuals

No comments