Sony CSS-HD1 Instruction Manual download pdf (Page 11)

11-GB

To use your Cyber-shot Station abroad

- Power sources

You can use the Cyber-shot Station and the AC

Adaptor (supplied) in any country or region where

the power supply is within 100 V to 240 V AC

50/60 Hz.

Use a commercially available AC plug adaptor,

if necessary, depending on the design of the wall

outlet (wall socket).

AC plug adaptor

(not supplied)

Do not use an electronic transformer (travel

converter), as this may cause a malfunction.

Preparing the remote control

Notes on the remote control

The remote control is powered by a button type

lithium battery (CR2025) installed at the factory.

An insulation sheet is inserted to avoid the battery

exhaustion. Remove the insulation sheet before

using the remote control for the first time.

Insulation sheet

Point the remote sensor of the Cyber-shot Station

away from strong light sources such as direct

sunlight or overhead lightings. Otherwise, the

remote control may not function properly.

The remote control range is less than five meters

(for indoor use). Point the remote control at the

remote sensor of the Cyber-shot Station. Try

adjusting the angle of the remote control if you

cannot operate the Cyber-shot Station.



Set up

Preparing the Cyber-shot Station

1 Set the MODEL SELECT switch.

See the table below and set the MODEL

SELECT switch to match with your camera.

MODEL SELECT

switch (

)

DSC-W200, DSC-W90, DSC-W85,

DSC-W80

DSC-T100, DSC-T25, DSC-T20

2 Connect the AC Adaptor to the DC IN jack

of the Cyber-shot Station.

To a wall

outlet

(wall socket)

Cyber-shot

Station

DC plug

AC Adaptor

AC Power cord

(mains lead)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Comments to this Manuals

No comments

Sony CSS-HD1 Instruction Manual Page 11

Comments to this Manuals

Related products and manuals for Unknown Sony CSS-HD1